Samsung SCX-RD100 user manual P q r, Top

Page 10

Introduction

Top

C

STATUS

POWER

 

RS-485

 

VIDEO

DC 12V

RS-232C

TX

RX

OUT IN

 

 

 

I

n o p q r

USB Port

-This terminal is used for updating the product’s firmware.

RS-232 Port (9-pin D SUB)

-Used to control remotely using RS-232 communication.

RS-485 Port (4-pin)

-Used to control remotely using RS-485 communication.

VIDEO IN/OUT Connector (BNC)

-VIDEO IN receives coaxial communication from cameras, and VIDEO OUT outputs the video signal.

DC12V Power Connector (2-PIN)

-Used for connecting DC12V power source.

10 – COAXIAL REMOTE CONTROLLER

Image 10
Contents SCX-RD100 Safety information Risk of Electric Shock Do not OpenENG Important Safety Instructions Contents Introduction FeaturesIntroduction List of controllable modelsPart Names and Functions Front PanelAddress AA Battery Rear PanelP q r TopChecking Installation Environment Installation PrecautionsConnection & Control Control of pan/tilt/zoom using the keys is not supportedTo Control the Camera Coaxial Communications ƒ Input of video signal is required to control RS-485 VIA Coaxial Communications To Control the Camera Using RS-485 Signal Output Connection & Control Switch Setting Table See the following table to set the baud rate Erna Baud Rate PIN Specifications SpecificationsDimensions Correct disposal of batteries in this product