Samsung SCX-RD100 user manual Address

Introduction

❺RS-485 TERMINATION & PROTOCOL Setting Switch

-You can select to set the RS-485 termination.

-Turn this switch ON, if RS-485 termination is required.

ONON

1 2 1 2 3 4 5 6 7 8

TERMINATION PROTOCOL

-For multi-protocol settings, you can set the protocol and baud rate, and selection of COAXIAL/RS-485 or RS-232.

ONON

1 2 1 2 3 4 5 6 7 8

TERMINATION PROTOCOL

-Use pin 1,2,3,4 of the Protocol setting switch to select a protocol.

-Use pin 5,6 of the Protocol setting switch to select a baud rate.

-Use pin 7 of the Protocol setting switch to select COAXIAL/RS-485 output.

-Use pin 8 of the Protocol setting switch to select RS-232 input.

❻Address Switch

-For RS-232 / RS-485 communications, you can use this switch to set the address.

ADDRESS

(X)100(X)10(X)1

1	2	3		1	2	3		1	2	3
		4				4				4
0			5	0			5	0			5
9		7	6	9		7	6	9		7	6
	8				8				8

-Set the address by using three switches shown above.

-From the left, the number is hundreds, tens and ones place, respectively. The effective range of valid address is between 0 and 255 (1~255 for multi- protocol).

ƒIf you specify the address as other than between 0 and 255, it will be set to 0.

NOTE

❼Menu Navigation Key

Use this to navigate through the menus.

P

❖

N

8 – COAXIAL REMOTE CONTROLLER