Samsung SCX-RD100 user manual To Control the Camera Using RS-485 Signal Output

Connection & Control

TO CONTROL THE CAMERA USING RS-485 SIGNAL OUTPUT

ENG

1.Connect the product to DC 12V power source or insert 4 AA-sized batteries into the battery compartment.

2.Set the protocol switches 7 and 8 to OFF.

3.Connect the RX(+/-) of the unit to the RS-485 (+/-) port of the camera.

4.Match the camera’s address, baud rate, and protocol to the same to those of the unit.

5.Now you can control the camera by using the menus.

❖You can use the menu as following :

–Press and hold [ENTER]: Moves to the main menu screen.

To exit the menu screen, press and hold the key again.

–Press [ENTER] briefly: Used to confirm the current settings.

–Four Direction Keys: Used to move the cursor up/down or left/right.

–Control of pan/tilt/zoom using the buttons is not supported.

ƒInput of video signal is required to control RS-485.

NOTE ƒ The next time you access the menu, press and hold the [ENTER] key twice.

English 15