Sharp VL-A10H Installing the Lithium, Memory Battery, Removing the Lithium Battery

Page 19

Installing the Lithium

5 Close the cassette compartment door by

Memory Battery

pressing the centre until it clicks into

place.

 

The supplied lithium battery is used to store the memory of the date and time settings.

1 Slide the cassette compartment door release and open the cassette compartment door.

Cassette compartment

 

door release

Removing the Lithium Battery

 

Perform steps 1 and 2 above, then lift out the

 

battery from the battery holder.

 

Note:

 

• Replace the battery with a new CR2025 battery

 

when the date and time indicator starts to fall

 

behind the correct time.

Note: The cassette holder will extend and

Notes on the Use of the Lithium

open when the VIEWCAM is connected to a

Battery

power source. Be sure to close the cassette

 

holder before proceeding to the next step

CAUTION: Danger of explosion if battery is

(see page 11).

incorrectly replaced. Replace only with the

 

2 Pull out the lithium battery holder using

same or equivalent type CR2025 recommended

by the equipment manufacturer.

a pointed object such as the tip of a

WARNING KEEP THIS BATTERY AWAY FROM

ballpoint pen.

CHILDREN. IF SWALLOWED, CONSULT A

 

PHYSICIAN IMMEDIATELY FOR EMERGENCY

 

TREATMENT.

 

CAUTION BATTERY MAY EXPLODE IF MIS-

 

USED OR INSTALLED WITH POLARITY

 

REVERSED. DO NOT RECHARGE, DISAS-

 

SEMBLE OR DISPOSE OF IN FIRE.

Preparation

Lithium battery holder

3 Insert the lithium battery into the battery holder with the ` side of the battery facing the j side of the holder.

j mark

4 Push the battery holder back into position.

•Do not short-circuit, recharge, disassemble, or heat the lithium battery.

•Should the lithium battery leak, wipe the battery compartment and holder clean, and then insert a new battery.

•The lithium battery will last about one year of normal usage.

12

Page 18 Page 20
Image 19
Page 18 Page 20
Contents VL-A10H Power supply Blue Neutral Brown Live Special Note for Users in the U.KAvoid shocks and dropping Do not aim the lens at the sunAvoid placing LCD Monitor Screen CleaningAC Adapter Iii Battery packCR2025 type Audio/video cable Lithium battery Remote control ×Soft case Tripod adapter For 180 recordingContents Gamma Brightness Compensation Useful FeaturesAdvanced Features ReferencesCassette compartment door p When the cassette compartment door is openPart Names Operation SummaryRemote sensor p Rear view35 p Camera ModeVCR Mode On-screen Display IndexQuick Reference Index Video cassette is defective and should be Inserting and Removing Battery PackInserting the Battery Pack Removing the Battery PackRecording and playback times Charging the Battery PackPowering the Viewcam from an AC Outlet Perform above, then take out the cassette Inserting and Removing a CassetteInserting a Cassette Removing a CassetteRemoving the Lithium Battery Installing the LithiumMemory Battery BatteryChanging to the 12-hour Time Mode Setting the Date and TimePress the SET button B LCD screen side Using the Hand Strap and the Lens CapAttaching the Shoulder Strap Attaching and Removing the Lens CapOpening the Sun Hood Using the Sun HoodAttaching the Sun Hood Closing the Sun HoodMaximum Continuous Recording and Actual Recording Times Easy Camera Recording with Full Auto ModeTo Turn the Power Off To Pause RecordingTips on Recording Positions ZoomingBasic Operations Camera Recording Approx. remaining On-screen Recording time Indicator Remaining Battery Power DisplayRemaining Recording Time Display Yback Volume ControlPlayback Asic OperationsTurn on the Viewcam in VCR mode, and begin tape playback see Watching the Playback on aStill Video SearchBasic Operations Playback Display button Useful FeaturesOperations of the On-screen Controls Menu buttonPerform steps 4 to 6 above Desired settingPress the SET button B to select Press the or button C or D to select the desired menu itemPress the button to select Select Recording the Date and TimePress the or button to select Display Press the SET button B to select AUTO, ON, or OFFType of Fade Modes Selecting Fade ModeUsing Fade Mode Fade In and Fade OutQuick Review To cancel Fade modeTo use fade out only Recording Standby mode, press Menu button until appears Quick Return Edit SearchPress the Gama EFF. button a again To cancel Gamma Brightness CompensationGamma Brightness Compensation To obtain a brighter pictureGain-up Cat’s Eye To cancel the gain-up functionTo return to normal picture Wide ScreenMacro Shots Removing the Lens HoodTo pause recording, press the REC Stop button B Self RecordingNormal Self Recording More Information on Self RecordingSelf-recording Message Press the Message button in Recording Standby modeTo turn off the self-recording message screen Setting the Viewcam to Full Auto Mode Program Search FeaturesUseful To turn off the tape counter Tape Counter FeatureUsing the Counter To reset the counter to zeroDuring playback, press the Menu Button until appears Using the Counter MemoryPress the Play button D to view the desired scene Turning On the Remote Control Mode Using the Remote ControlOperating the Remote Control Installing the Batteries in the Remote ControlType of Digital Picture Effects To cancel the digital picture effectAdvanced Features Digital Picture EffectsSelect Scene Menu in above Type of Scene SettingsTo cancel the scene setting Scene Menu Program AESuperimposing a Title Top of the screen and the cursor will Changing the Preset TitlesPress the Reset button to display the title input screen Press the or ß button Q to selectManual Focus To cancel Manual Focus modeAuto/Manual Focus Auto FocusWhite Balance Lock To cancel White Balance LockPress the White BAL. button. White BAL. returns to blue Manual Exposure To cancel Manual Exposure modePerform steps 1 and 2 above, then press the Auto button B Type of Backlight Modes Picture/Backlight AdjustmentsPress the Menu button until Camera mode or VCR mode appears Press the Exit button to turn off the adjustment screenPress the Gama EFF. button again. Gamma disappears To cancel Gamma PlaybackGamma Playback Turning Off the LCD Monitor BacklightTo stop editing Setting Edit ModeEditing Cutting Unwanted SequencesTips on Good Lighting Useful InformationHints for Better Shooting LightingDirty Video Heads Dew FormationReplacing the Fluorescent Lamp Battery PackReferences Video Cassette Tapes Using Your Viewcam AbroadUse only tapes with the mark with this Watching the Demonstration Demonstration ModeCancelling Demo Mode Button and slide Power switch toPower Camera mode Symptom Possible cause Suggested solution Before Requesting ServiceVCR Viewcam Specifications0P06-M-G
Top Page Image Contents