Toshiba IK-53V instruction manual HD/VD Output Amplitude Specifications, HD Input Specifications

Page 16

5. Input Output Signal Specifications

HD/VD Output Amplitude Specifications

HD

 

 

 

4.5V

 

 

0V

VD 4.5V

0V

The amplitude level is the representative value when terminated with 10kΩ. Output is enabled when the rear panel HD/VD signal input/output switch is set to the INT side.

HD Input Specifications

2.0 to 5.0Vp-p

2.0∝s to 5.0 ∝s

*Input impedance: 75Ω or 10kΩ or greater

*Input amplitude 2.0 to 5.0 Vp-p (75Ω termina- tion ON or OFF)

*Voltage and pulse width were measured at pin 6 of the 12-pin connector located on the rear panel.

VIDEO INDEX Output Specifications

4.5V

0V

525H (Partial scanning OFF)

175H (Partial scanning ON)

Trigger Pulse Specifications

2 to 5.0V

0 to 0.4V

(Positive polarity mode)

More than 2∝s

The amplitude level is the representative value when terminated with 10kΩ.

More than 2∝s

2 to 5.0V

0 to 0.4V

(Negative polarity mode)

VD Input Specifications

2.0 to 5.0Vp-p

5H to 21H

*Input impedance: 75Ω or 1kΩ or greater

*Input amplitude 2.0 to 5.0 Vp-p (75Ω termina- tion ON or OFF)

*Voltage and pulse width were measured at pin 7 of the 12-pin connector located on the rear panel.

*Input impedance: 10kΩ or greater

*Voltage and pulse width were measured at pin 11 of the 12-pin connector located on the rear panel.

PART Input Specifications

H:2.0 to 5.0 V

L:0 to 0.4 V

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents IK-53V/IK-52V FCC StatementContents General Camera Parts and Functions Top/Bottom/Front SideRear Side EnlargedConnections Connector Pin AssignmentsStandard Connection Setting Bit Pin 9 of the 12-pin connec Mode Tor on the rear panelVideo Scanning Modes Partial Scanning OFF All pixels scanningWhen Partial Scanning Mode is on Partial Scanning onElectronic Shutter Description of the Mode Select SwitchNormal Shutter Reset Restart Long Term ExposureExternal Trigger Mode External Trigger Shutter Speed SettingVD OUT*3 Video Index Video Index Pulse Width Trigger SYNC-RESET Picture Output Timing Shutter mode HD input VD input Pulse Trigger SYNC-RESET Picture Output TimingExternal Sync Operation HD/VD Output Amplitude Specifications HD Input SpecificationsVideo Index Output Specifications Trigger Pulse SpecificationsExternal HD/VD Input Phase Specifications Normal modeReset-restart/external trigger mode External VD falling edgeHorizontal Output Waveform Timing Chart Vertical Output Waveform Timing ChartIK-53V Exterior ViewIK-52V Specifications Spectral Sensitivity Characteristics Representative Values
Top Page Image Contents