Toshiba CSGU15CC18, CSGX36CC3, CSGV90CC3, CSGS20CC2, CGSV90CC3 Electronic shutter mode switching

Page 37

(8)Electronic shutter mode switching

You can switch the shutter modes by adjusting the setting value of the command status register of the camera

via the Gigabit Ethernet. The setting method has two kinds of the following.

- AE (Auto Exposure)

The brightness is adjusted automatically by the average photometry of the entire screen.

・Effective range

1/20000s to Setting value of the frame rate

・Effective area

Full screen

・Exposure level

-1EV to +1EV (1/3EV step)

By combining this mode and AGC (ALC mode), it can follow so much to brightness change of subject.

- Normal shutter

Performs exposure control via the internal synchronization signal.

・PRESET mode:

1/100, 1/250, 1/500, 1/1,000, 1/2,000, 1/4,000, 1/10,000

 

and 1/20,000s

・Absolute value setting:

Any value is set up in 32-bit floating point form within the range

 

of 1/20000s to 2s

- Random trigger shutter:

Random trigger shutter can capture images at any timing using the external trigger signal and soft trigger

input. It is effective for image input of moving objects and obtaining images of the same timing using

multiple cameras. But there is an exposure delay time.

The random trigger shutter of this camera can be operated in two types of mode. How to determine the

exposure time differs depending on the mode.

・Fixed mode:

The exposure time depends on the normal shutter speed setting.

・Pulse width mode :

The exposure time depends on the pulse width.

Notes on long exposure:

-When you set the exposure time longer than approximately 1 second, white spots and the unevenness in highlight portion might occasionally be observed on screen. This phenomenon is due to the characteristics of the CCD image-pickup device, and do not reflect performance error in the pickup device or CCD Camera itself.

(4/16)

D4153497A

 

Page 36 Page 38
Image 37
Page 36 Page 38
Contents CSGV90CC3 CSGX36CC3 CSGS20CC2 CSGU15CC18 Definition of Safety Signs Description Safety PrecautionsExplanation of Safety Symbols Description Do not place anything on the equipment General HandingUse the specified voltage Avoid giving a strong shock against the camera body When performing connection, turn off powerCases for Indemnity Limited Warranty Handle carefully MaintenanceEnvironmental operating conditions Check a combination with the lensFollowing information is only for EU-member states Others Overview FeaturesOptional part ConfigurationLED2 Explanation rear panelConnection CSGV90CC3 CSGX36CC3 CSGS20CC2 CSGU15CC18 Functions34fps 46fps Minimum unit size 160 x Expose GbE bus Timing chartTrigin Troubleshooting Electrical specification Specifications［Trigger signal specification］ Internal sync signal specificationOutput signal specification Interface specification ［Electronic shutter specification］［Operating Ambient conditions］ ［Machine externals specification］［Typical spectral response］ CSGU15CC18 Outline Drawing D4153660A D4153660A Distributor CSGV90CC3 CSGX36CC3 CSGS20CC2 CSGU15CC18 Cases for Indemnity Limited Warranty Restriction for USE Regarding a lens mount Maintenance Overview Camera body Gain setting Setup-level settingWhite balance Gamma correctionElectronic shutter mode switching Scalable mode Number of total pixels 692 x Trigger signal specification Electronic shutter specification Operating ambient conditions Machine externals specificationTrigin Typical spectral response 12/16 27.8 25.2 Repair Guarantee16/16 Distributor
Top Page Image Contents