QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 25
Your Qflash is factory preset with several Programs (which you are free to change). To view them, press Mode I, then Up J/Down L until you see the Program mode displayed, like above. After the “P” stops blinking, press the Up J/Down L buttons to switch to the next higher, or lower program number. (Programs which have not been preset are considered “clear” and will be skipped).
How to set up or change a Program
While in the Program mode, press the Set G button. The program number will blink, and the Up J/Down L buttons will select the program number you wish to set or change. All program numbers will be displayed this way, even those that are “clear”.
Press Set G again (or press it twice if the Program number stopped blink- ing). The mode (Manual, Auto, TTL, etc.) will be blinking. Up J/Down L to select your flash mode for this program.
Once your flash mode is selected keep pressing Set G to choose param- eters to program. To change any settings use the same procedures used for Manual, Auto, TTL, or Wireless/Wired modes.
There are times when you will want to “clear” a Program from memory. Clearing unwanted programs allows for quicker switching between stored programs during actual shoots. For example, if you need just 3 Programs for a job, and you clear out the other 5 Program numbers, you will cycle through just the 3 Programs you want for a shoot, using the Up J/Down L buttons.
To clear out a Program
Start in the Program number you wish to clear. Press Set G until the ‘mode’ blinks in the display. Press Up J/Down L until the word CLEAR appears. After several seconds the display will stop blinking and the program will be cleared from memory. Note: You can never clear out Program 1.
14.WIRELESS QFLASH OPERATION WITH FreeXWire
Qflash
Important: Note the series of FreeXWires and QTTL Adapters indi- cated in each setup to be assured of proper operation.
21