QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 33
15. WIRED CONTROL MODE
Qflash’s Wired Control Mode is a versatile tool for precise lighting control. One Qflash is designated as the “Control”, and from its panel the photog- rapher can change the modes or settings on one or two “Remote” Qflashes.
The physical setup for Control Mode is shown below. The camera adapter must be a QTTL series D, Dw, or
Wired Control
The basic steps for Wired Control Mode setup are:
•Set the
•Using the Control Qflash panel, select the operating Mode and settings for Control, Remote 1 and/or 2.
15.1 Set up the Control Unit
The number of Qflashes can be 2 or 3. Turn on all Qflashes. The Qflash displays will prompt you to select the Control flash for the “Wired Control” setup. Press the Mode I button on the Qflash that you want to be the Control Qflash (usually the one at the camera).
The display will change to ”Wired Control”, and show the data for Remote 1 ( R1 ) and Remote 2 ( R2 ).
29