QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 36
16.2 Wireless lighting ratios made easy
When using multiple lights to light a subject it’s very easy to set up a light- ing ratio between the Main and Fill lights. The ratio can be set from
Equipment needed:
•One Qflash
•One Qflash (any version) located to the right of the subject
•Two FreeXWires
•Two QF30 cables
•Two Quantum Turbo batteries
Set up:
•Connect the equipment as shown.
•Set the Main flash to TTL mode.
•Set the Fill flash, located at the camera
position to Auto mode. Select an F number that is less than the
F number set on the camera. Typically it is set to one stop under the camera’s aperture, but can be as low as
•Next Adjust the Linked ratio for the difference between Fill flash and the camera’s aperture.
Example. If the camera is set for F8.0, and the Fill is set for F5.6, the Linked ratio needs to be set to +1 ( the camera is one stop higher than the Fill)
16.3 Lighting ratios using a control cable
This set up is similar to the wire- less one above, only Qflashes are connected with QF50 cables instead of FreeXWires.
Equipment needed:
•One Qflash
•One Qflash / 2/ 2d/4d/5d located to the right of the subject
•One QF50 control cable
•Two Quantum Turbo batteries
Set up: Same set up as above.
32