Olympus FFL 50 manual Opening Levers

Page 10

OPENING LEVERS

After unscrewing and pulling out the pressure release plug, the lid can be opened. To overcome the friction of opening, two levers are used to push against the lid with a cam action. On some models these opening levers are bolted to the body. On the other models, they are detachable levers.

Important!

Be sure they are inserted all the way flat to the housing before turning to avoid damaging the protrusions on the lid.

The body has two holes on opposite corner edges of the housing for opening. Gently lever off the lid with the supplied cams taking care not to twist the lid excessively. The lid should be opened keeping it approximately parallel to the body at all times. If using a single lever, turn first one side a little, then the other an equal amount, and repeat again until the lid is opened. Remember to unscrew and pull out the pressure release plug all the way first, otherwise the air pressure will resist attempts at opening. Lay the lid on a flat stable surface after opening.

Cam Levers

Cam Lever in Housing

10

Image 10
Contents Fantasea FFL 50 Flash Housing for the Olympus FL50 Flash Table of Contents General Specifications Fantasea FFL 50 Flash HousingGeneral Flash Housing Description General InformationFeatures and Accessories Included with the Housing Back of Housing Function ControlsMaintenance of the Main Gasket Seal Materials NeededWhen to Maintain the Gasket Seal Page Exclusive Pressure Release Plug Opening Levers Mounting the Speedlight in the Housing InsertingClose Housing Replace the LIDAttaching the Sync Cord Attaching Flash Housing to ARM Cleaning & Storage Battery LifeCare and Maintenance Traveling ServiceAccidents Warranty Fantasea Housings ONE Year Consumer Limited Warranty