Olympus FFL 50 manual Attaching the Sync Cord

Page 13

ATTACHING THE SYNC CORD

The sync cord is a 5 pin Nikonos type sync cord. The sync cord connects the flash to the camera housing. Both ends of the cord are identical so either side can be inserted into the flash and camera housings. When you insert the cord into the port you must exercise caution—the pins inside the cord are delicate and must not be damaged.

1.Unscrew the port cover cap and store in a safe place. Gently and accurately attach the sync cord to the port of the flash housing.

2.While securing the position of the sync connector, screw it into the housing using the locking screw of the sync cord.

Caution

LINE UP THE CORD TO THE HOUSING IN THE FOLLOWING MANNER:

On the side of the housing port notice a simple alignment indicator [dot]. The 5 pin cord contains a small channel [groove] between 2 of the female pins of the cord.

You must insert the cord into the port so the groove is aligned with the indicator of the housing. This assures proper alignment. Hold firmly in place while fastening locking screw.

13

Image 13
Contents Fantasea FFL 50 Flash Housing for the Olympus FL50 Flash Table of Contents General Flash Housing Description Fantasea FFL 50 Flash HousingGeneral Specifications General InformationFeatures and Accessories Included with the Housing Function Controls Back of HousingMaterials Needed Maintenance of the Main Gasket SealWhen to Maintain the Gasket Seal Page Exclusive Pressure Release Plug Opening Levers Inserting Mounting the Speedlight in the HousingReplace the LID Close HousingAttaching the Sync Cord Attaching Flash Housing to ARM Cleaning & Storage Battery LifeCare and Maintenance Traveling ServiceAccidents Fantasea Housings ONE Year Consumer Limited Warranty Warranty