MOUNTING THE SPEEDLIGHT IN THE HOUSING
INSERTING
Since the Fantasea FFL 50 Flash Housing was specifically designed for the Olympus FL50 Speedlight, insertion is a simple matter of placing the flash into the housing. Make sure the flash is properly aligned and that it sits perfectly flat. There are no screws or mounts to worry about or any other alignments once the flash is properly inserted.
Set the flashlight in an upright position. Slide the flashlight all the way into the hot shoe of the housing until it stops
Notes:
1.It is recommended first to attach the flash to the camera's hot shoe to determine if it is functioning properly.
2.Once this is determined, insert both into their respective housings.
Turn the lock ring follow the direction “LOCK”. Take care not to excessively tighten the screw. Note: If you find that control levers do not locate properly with the buttons, please check again that the flashlight is properly seated to the limit of the guide rail.
FIGURE 3: SLIDE IN AND LOCK THE FLASHLIGHT
11