Olympus FFL 50 manual Close Housing, Replace the LID

Page 12

FIGURE 4: REPLACE THE LID

CLOSE HOUSING

1.Place housing back over front and align the complete mating surface of the housing and the gasket, forming a proper seal.

2.Ensure that the pressure release plug is pulled all the way out while closing, otherwise the air cannot escape.

3.Squeeze the lid closed all the way, you will hear the hiss of air being expelled.

4.Screw home the pressure release plug; you need not excessively tighten this plug. The seal is made by the internal O-rings. The O-ring on the underside of the plug is just to keep out dirt and other debris. Plug is shown in Figure 4 above.

5.Inspect the gasket seal for proper closure. A complete seal can be visually confirmed by looking for the black line made by the gasket around the complete circumference of the housing.

Note!

After replacing the lid, make a final visual inspection of the main gasket for contamination. The seal is made by the internal gasket.

 

 

 

FIGURE 5: INSPECTION OF O-RING

 

 

 

 

 

Note!

 

If the gasket is in good contact, a thin black line, about 0.5-1mm in

 

 

width should be visible where the gasket is in contact with the lid.

 

 

Follow this line all the way round the edge of the seal as a final check

 

 

 

that the seal is good. The housing is now ready for the dive.

12

Image 12
Contents Fantasea FFL 50 Flash Housing for the Olympus FL50 Flash Table of Contents Fantasea FFL 50 Flash Housing General Flash Housing DescriptionGeneral Specifications General InformationFeatures and Accessories Included with the Housing Back of Housing Function ControlsMaintenance of the Main Gasket Seal Materials NeededWhen to Maintain the Gasket Seal Page Exclusive Pressure Release Plug Opening Levers Mounting the Speedlight in the Housing InsertingClose Housing Replace the LIDAttaching the Sync Cord Attaching Flash Housing to ARM Battery Life Cleaning & StorageCare and Maintenance Service TravelingAccidents Warranty Fantasea Housings ONE Year Consumer Limited Warranty