Sanyo LNS-W03 Lens Replacement and Installation Procedure Type 1 Cabinet, Fig-1, Fig-2, Fig-3

LENS REPLACEMENT AND INSTALLATION PROCEDURE (Type 1 Cabinet)

Perform the steps

1

to

5

for lens replacement and installation.

First set the lens at the center position with lens shift adjustment.

1 REMOVE THE LENS COVER. (See figure-1)

1.Remove screws A (2 screws).

2.Pull down the lower lens cover while pushing the part D, then remove it.

3.Remove screws B (2 screws).

4.Remove screws C (2 screws) and remove upper lens cover.

2

●IN CASE OF MODEL WITHOUT LENS

UPPER LENS COVER C

B

D

D	Fig-1
A	LOWER LENS COVER

REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)

Remove 2 screws and pull down the plate.

(At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used.)

Disconnect the Lens Shift connector	SCREWS
("K16A") from circuit board. (See Fig. 3.)
	COVER PLATE

●IN CASE OF MODEL WITH LENS

Fig-2

REMOVE THE LENS. (See figure-3.)

1.Disconnect the Lens Shift connector “K16A” from circuit board.

2.Disconnect the Zoom and Focus con- nector “K16B” from circuit board.

3.Loosen the A, B wire holder and remove the lens motor lead.

4.Remove screws D (4 screws) which fastens the lens and remove the lens.

❋Figure shown inside of the cabinet. LENS MOTOR

(D)(D)

A

(D)(D)

B

A

LENS

MOTOR LEAD

Fig-3

CONNECTORS " K16A" and " K16B"

-2-