Sanyo LNS-W03 manual Fig-4, Fig-5

Page 4

3

INSTALL THE LENS. (See figure-4)

1.Remove protective caps(front and back) on the lens.

2.Mount the lens on mounting bracket of the main cabinet with 4 screws.

Use the screws included with the lens. Use the driver included with the lens to fasten the screws.

(After using, keep it for latter use.)

ATTACHED DRIVER

4 INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)

Install the light-block sheet around the lens as shown in the illustration. Use the sheet included with the lens.

Make sure the part no. and mark (TOP and BACK) on Light-Block Sheet and set them properly.

ADJUST FOCUS

Adjust focus following Focus Adjustment on page 6.

LENS MOUNTING BRACKET

Fig-4

LIGHT-BLOCK SHEET

Type FE1

(Part No. 610 280 2634)

Fig-5

5 MOUNT THE LENS COVER. (See figure-6)

When in install the both upper and lower

UPPER LENS COVER

 

lens covers, install the light-block sheet so

 

A

that it should be placed in the guide slot.

 

 

 

(place of the cover plate had been placed.

 

 

See figure-2.) If the installation of light-block

 

 

sheet is incorrect, it will be the cause of

 

 

leakage of light or the dust entering at the

 

 

main cabinet.

 

 

1. Insert the upper part lens cover and fix

 

 

them with screws A (4 screws).

 

 

2. Insert the lower part lens cover and fix

A

 

them with screws B. (2 screws).

 

 

 

B

Fig-6

 

LOWER LENS COVER

-3-

Image 4
Contents Type of the Cabinet and Installation Procedures Type of the Cabinet 1 See Type of the Cabinet 2 SeeBe Sure to Check for Safety List of ContentsLens Replacement and Installation Procedure Type 1 Cabinet Fig-1Fig-2 Fig-3Fig-4 Fig-5Lens Replacement and Installation Procedure Type 2 Cabinet Fig-6 Focus Adjustment Fig-7