(1) Operation by Zoom Seesaw Control Lever
a.Set the zoom servo/manual select knob to “SERVO.”
b.Press the zoom seesaw control lever. Press
(2) QuickZoom Operation
RETURN SWITCH |
VTR SWITCH |
In quickzoom operation, pressing a switch moves the zoom to the tele end quickly. The operator can use this function in such occasions listed below.
•When rapid zooming to the tele end is required to focus on the object precisely.
•To confirm, in a moment, the composition of the image in the extreme closeup shot.
Either the VTR switch or the return switch can be used as a quickzoom switch. Set switch 1 or 2 in the area of “Function & Mode Select Switches” (see page 13) to ON. When switch 1 is set to ON, the VTR switch acts as a quickzoom switch, while when switch 2 is set to ON, the return switch acts as that switch. In the following description, the VTR switch or the return switch is called quickzoom switch.
Operation
a.Set the zoom servo/manual select knob to “SERVO.”
b.Keep pressing the quickzoom switch until the zoom reaches the tele end.
c.While pressing the quickzoom switch, perform precise focusing or confirm the composition of the image in the extreme closeup shot.
d.Release the quickzoom switch.
–The zoom will move to its former position quickly.
(If you press the quickzoom switch again before the zoom returns to its former position, the quickzoom movement restarts. After this operation, if the switch is released, the zoom will move to its former position quickly. )
Note 1. In quickzoom operation, the zoom moves at the maximum speed.
Note 2. If you press the quickzoom switch while pressing the zoom seesaw control lever, the zoom moves in auto cruising zoom operation, not in quickzoom operation.
– – |