Tyco ADC 660P instruction manual Power Indicator LED, Backfocus Adjustment Screw

Page 14

Hi-Res. B/W camera instruction manual

ADC 660N and ADC 660P

_________________________________

Monitor Screen

LEVEL Control Direction

 

 

To increase the brightness

Clockwise

 

 

To decrease the brightness

Counterclockwise

 

 

12.Power Indicator LED

This LED turns ON only when power is supplied properly and the DC-DC converter (or the regulator) inside the camera works properly.

13.Backfocus Adjustment Screw

This screw is used to position the CCD image sensor at the precise point of focus of the lens.

Backfocusing Fixed-Focal or Vari-Focal Length Lenses

Install a lens and connect the camera to a monitor and power supply as described in this manual.

Open the iris completely or just before there is blooming in the picture. If an Auto Iris lens is used, reduce the room lighting to use a neutral density filter to allow the lens to open completely. This gives the most accurate results.

Adjust the screw slowly until the sharpest picture is obtained. This completes the adjustment. The back-focus adjustment screw is held in place by friction, so there is no locking screw to tighten.

Backfocusing Zoom Lenses

Install a lens and connect the camera to a monitor and power supply. Position the camera 10~30 feet (3~9 meters) from a flat vertical surface suitable for focusing. A newspaper works well as a focusing target.

Open the iris completely or just before there is blooming in the picture. If an Auto Iris lens is used, reduce the room lighting or use a neutral density filter to allow the lens to open completely. This gives the most accurate results.

1.Zoom the lens in to the maximum telephoto setting. Adjust the optical focus of the lens for the sharpest picture.

2.Zoom out to the maximum wide angle setting. If the picture is no longer in focus, readjust the back-focus screw to obtain the best focus possible.

3.Repeat steps 1 and 2 until the image remains sharp through the entire zoom range without having to make any focus adjustments.

This completes the adjustment. The back-focus adjustment screw is held in place by friction, so there is no locking screw.

14

Image 14
Contents ADC 660N ADC 660P Equipment Modification Caution Page Use a 24V AC / 12V DC class 2 LPS supply only Do not attempt to disassemble the cameraNever point the camera toward the sun ADC 660N and ADC 660P Connectors and Controls Video Output Connector BNC Video Output Connector BNC Power Input Connector screw terminalAuto Iris Lens Connector for Video Drive Lens Auto Iris Lens Connector for DC Drive LensBLC Backlight Compensation ON/OFF Switch ALC/ELC Select Switch EE/ELC is on ALC/AI is OFF FL on Switch Flickerless ON/OFF AGC ON/OFF SwitchINT/LL Switch LL is on INT is OFF Phase Adjustment PotentiometerCamera As Video OUT Camera Bs Video OUT ALC Level Adjustment Potentiometer for DC Drive Lens Power Indicator LED Backfocus Adjustment ScrewADC 660N and ADC 660P Camera Mount Hole Camera Mount Base Mount Adaptor RingCCD Dust Protective Cap One monitor system with two or more cameras III. Dimensions IV. Specifications