Tyco 8200-2646-00 B0 Frame rate Format, Fine Tune mode White Balance, 255, Parameters on this

Installation and Operation Guide

Frame rate:

Format:

Click on the drop-down list to choose the frame rates of “5FPS”, “10FPS”,

“15FPS”, “24FPS” or “(25) 30FPS”.

Click to choose the “MJPEG” or the “MPEG4” mode.

Fine Tune mode:

	White Balance:		Scroll to choose the mode from “Auto”, “Fluorescent (3200K)”, “Indoor
			(4200K)”, “Outdoor (6500K)”, ”Push Hold”.
	Flickerless:		Mark the “Flickerless” “ON” or “OFF”. Click your choices to enable.
	Mirror:		Mark the “Mirror” “ON” or “OFF”. Click your choices to enable.
	High Speed Shutter:		Mark the “High Speed Shutter” “ON” or “OFF”. Click your choices to
			enable.
	BLC Mode:		Scroll to choose from “Disable”, “Weighted” or “Fixed Gain”.
	Backlight:		Select in the backlight level in the blank (0 to 255).
	Brightness:		Select your desired quality of image brightness from a spectrum of 0 to
			255.
	Contrast:		Select the contrast level in the blank (0 to 255).
	Saturation:		Select the saturation level in the blank (0 to 255).
	Sharpness:		Select the sharpness level in the blank (0 to 255).
MJPEG mode:
	Viewer type:		Click to choose the viewer type of the “ActiveX” or “AJAX” mode.
	MJPEG Deinterlace:	Click to choose the MJPEG Deinterlace of the “ON” or “OFF” mode.
	Submit:		Click to submit the new image setting to the IP camera.
	Default:		Click this button to install the default settings in all the entries for image
			parameters on this page.

35