Axis Communications 221 user manual Event Configuration, Event Servers, Definitions

AXIS 210/211/211A - Event Configuration 25

Event Configuration

An event in the camera is when an Event Type is activated and causes certain actions to be performed. The event type is the set of parameters (or conditions) that specifies how and when which actions will be performed. A common event type is when the camera uploads images when an alarm occurs. Many event types use an Event Server, to e.g. upload images to.

This section describes how to set up event servers and event types, i.e. how to configure the camera to perform certain actions when events (e.g. alarms) occur.

Definitions

Event type	A set of parameters describing how and when the camera will perform certain actions
Triggered Event - see page 26	The circumstances that start an event.	E.g. on a signal from an external device, such as a
		door switch or a motion sensor.
Scheduled Event - see page 27	Time period(s) in which an event will	Pre-programmed time periods.
	run.
Action	What occurs when the event triggers.	E.g. the upload of images to an FTP server, email noti-
		fication, etc.

Event Servers

Event Servers are used to receive e.g. uploaded image files and/or notification messages. To set up Event server connections in your camera, go to Setup > Event Configuration > Event Servers and enter the required information for the required server type.

Server type	Purpose		Information required
	•	Receives uploaded images	•	Descriptive name of your choice
			• Network address (IP address or host name)
			• User Name and Password (for FTP server)
FTP Server			•	Upload path e.g. images/
			•	Port number
			• Use passive mode if there is a firewall between the camera
				and FTP server
	•	Receives notification messages	•	Descriptive name of your choice
	•	Receives uploaded images	•	URL (IP address or host name)
HTTP Server			•	User Name and Password (for HTTP server)
			• Proxy address/Proxy port (if required)
			• Proxy User Name and Password (if required)
	•	Receives notification messages	•	Descriptive name of your choice
TCP Server			• Network address (IP address or host name)
			• User Name and Password (for TCP server)
			•	Port number

For details on each setting, please see the online help available from each web page.

When the setup is complete, the connection can be tested by clicking the Test button (the connection test takes approximately 10 seconds).