Axis Communications 221 user manual Power Connector Block, Pin Function

Page 45

AXIS 221 - The I/O Units Connectors 45

Power

Power can be supplied to the camera through the following methods:

•the supplied power adaptor, PS-K, 9W. The center pin is positive (+).

•PoE (Power over Ethernet) with power classification, Class 2 via the network cable. This will automatically be detected if available via the network.

•the power connector block on the rear panel.

Power Connector Block

The power connector block can handle both AC and DC input power.

The DC supply is 7-24V, DC. Connect the negative pole to the GND pin and the positive pole to the DC+ pin.

The AC supply is 10-24V, AC. Connect the AC poles to the AC pins.

A diagram of the power connector block, complete with pin assignment table, is shown below.

Pin	Function

GND	Ground/DC-
AC/DC+	AC and DC+, power input for mains power to unit
AC	AC power input for mains power to unit

AC AC

GND DC+

Image 45

Contents Axis 221 Network Camera User’s Manual About this Document Contents Axis Product Features Rear panel OverviewPower LED IndicatorsNetwork StatusAccess From a Browser Accessing the CameraSetting the Password Accessing the camera from the InternetFocusing Live View Axis 221 Accessing the Camera Accessing the Setup tools ConfigurationBasic Configuration Overview of the Setup toolsSystem Options Administrators only Video and Image Image SettingsVideo Stream Overlay/Mask SettingsTest Overlay/Mask TypeCamera Settings Advanced SettingsOverlay image/privacy mask requirements Image Formats Image SizeProfile@Level Properties MPEG-4 SettingsAxis Media Control Live View Config Custom SettingsUpload Own Web Files Own Home Modify the Axis LookAction Buttons Example Check Show Custom LinkAxis Media Control Settings see Axis Media Control, on Default Video Format in Internet Explorer for WindowsDefault Viewer for Motion Jpeg Html ExamplesExternal Video Sequence ModeEvent Configuration Event ServersDefinitions How to set up a triggered event Configuring Event TypesTriggered Event Click Add triggered on the Event typesScheduled Event Pre-trigger and Post-trigger buffersMotion Detection Object Size Port StatusSecurity System OptionsIP Address Filter ViewerHttps Date & TimeNetwork Advanced TCP/IP Settings Network Basic TCP/IP SettingsIP Address Configuration ServicesHost Name Configuration Link-Local AddressNetwork Traffic Network Smtp email Network SocksNetwork Snmp Network UPnPLED Settings MaintenancePorts & Devices Support ConfigurationResetting to the Factory Default Settings Using the Reset ButtonAdvanced Setup Basic Configuration TroubleshootingChecking the Firmware Upgrading the FirmwareAxis Support Emergency Recovery ProcedureSymptoms, Possible Causes and Remedial Actions Default MPEG-4 decoder Status and Network indicator LEDs are flashing red rapidlyVideo/Image problems, general Image degenerating when viewing MPEG-4 Lower frame rate than expected when viewing MPEG-4Problems uploading files Poor quality snapshot imagesI/O Units Connectors Terminal ConnectorPinout and Interface Schematic Diagram Terminal Connectors Power Power Connector BlockPin Function D-Sub Connector Schematic Diagram Power Terminal Block and Power ConnectorsPin Removing and Attaching Lens Replacing the LensLens Technical SpecificationsSpecification Mtbf Dimensions HxWxD and weightGlossary of Terms Page AMC IndexScheduled Event 25