SVAT Electronics Q1404 instruction manual FIG-1, Installation, Wiring Diagram

Page 5

INSTALLATION

CAUTION: Before connecting the power and switching the unit ON make sure all wiring is connected properly.

1.Connect the power cable (supplied) to the back of the monitor.

2.Using the DIN cable connect the four cameras to the back of the monitor. Each end of the cable

will only fit in either the camera or the monitor. Align the pins on the connection jack, do not force the plug, it should go in freely. (FIG-1)

4.When using only 1-2-3 cameras the empty channel will remain grey.

5.Using a standard RCA Cable (not supplied) you can connect the monitor to an extra monitor/vcr or add additional cameras (use the BNC adapters provide to convert the BNC slots to RCA)

WARNING: When using BNC camera input jacks do not connect another camera to the same channel using a DIN connection. There is only one camera allowed per channel.

WIRING DIAGRAM

(FIG-1)

5

w w w . s v a t . c o m

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Q1404 Table of Contents Introduction Back View Front ViewFIG-1 InstallationWiring Diagram FIG-2 FIG-3 FIG-4 HOW to OperateSystem Setup Auto Adjust TroubleshootingAlarm History ExitZoom SpecificationsGraphic Symbol Explanation Product WarrantyCe qui est inclus VUE Arrière VUE DE FaceDiagramme DE Câblage Comment Fonctionner Installation DE Système Dépannage Histoire DalarmeLautomobile Sajustent SortieBourdonnement Moniteur 14 QuadGarantie DE Produit Explication Graphique De SymboleW . s v a t . c o m
Top Page Image Contents