ENFORCER Mini PTZ Camera
PATTERN SETUP Menu
From DOME CAMERA SETUP
PATTERN SETUP
PATTERN NO. 1 UNDEFINED
CLR PATTERN CANCEL <EDIT PATTERN>
BACK
EXIT
Configures up to four pan/tilt patterns, with each pattern consisting of a starting position, an ending position, and the complete pan/tilt/halt movement between those two points .
| [1 ~ 4] |
| Selects which PATTERN number to edit. If the |
PATTERN NO | selected PATTERN number has not yet been |
| programmed, "UNDEFINED" will be displayed |
| under the selected PATTERN number. |
| [CANCEL / OK] |
CLR PATTERN | Choose "OK" to delete the data in the selected |
| PATTERN |
<EDIT PATTERN> | Goes to the "EDIT PATTERN" menu. See below. |
EDIT PATTERN Menu
From PATTERN SETUP
EDIT PATTERN 1
MOVE TO START POSITION [NEAR:START /FAR:CANCEL]
EDIT PATTERN 1
[NEAR:SAVE /FAR:DELETE]
0 / 0 / x 1 / N
1.Use the joystick or arrow keys to move the camera view to the appropriate starting position for the pattern, and set the desired zoom.
To start the pattern recording, press the NEAR key. To exit this menu without saving the pattern, press the FAR key.
2.Use the joystick or arrow keys to move the camera along the desired path until the end. As the camera is moving, the path is being saved into its memory.
Note: While setting the PATTERN, any time the camera pauses will also be saved as part of the pattern.
The total memory size and available memory is displayed on the screen as a bar.
3.To save this pattern, press the NEAR key. To cancel the recording of the PRESET pattern, press the FAR key.
| 29 |