SVAT ELECTRONICS
now you can see
6.3.4 Motion Detection
You can use these settings to adjust the area and sensitivity of motion detection on each camera channel. These settings are important if you are using motion activated recording, because if adjusted correctly, they can help prevent false triggering of motion recording.
1.Channel – Select the camera channel in which you would like to make changes
2.Set Detection Area – Select this setting to enter a grid screen for the selected camera channel. In this screen you can set the areas in the camera’s view that you want to enable or block motion detection in. For example, if there are cars constantly driving by in an area on your camera, you can block that area from detecting motion. Use the directions below to set up motion detection areas:
Area Block Color:
•Grey: Detection Block. These areas will be detected
•Transparent:
•Green: Flashes when motion on the camera is being detected.
Use the green flashes to determine where motion is consistently being detected, and then make sure to set the motion detection area to exclude these areas from motion detection. Follow the directions below:
•Press “SEARCH” button to enable whole detection area.
•Press “MENU” button to disable whole detection area.
•You can set up a maximum of 3 separate detection areas (Detection areas may overlap):
•Press the” UP/ DOWN/ LEFT/ RIGHT” buttons to setup the starting point of the detection area.
•Press the “ENTER” button to confirm the starting point of the detection area.
CLEARVU4 | 14 |