FINAL ADJUSTMENTS (ALL INSTALLATIONS)
1.Turn the projector on with the UH480 Lens out of the projector beam. Set the horizontal lens shift to neutral (if a feature of your projector) and then adjust the ceiling mount so that the 16:9 image is in the exact center of and square to the screen, with a similar amount of image slightly over the top and bottom screen borders. If the projector lens is not in the exact horizontal center of the screen you may need to use a little horizontal lens shift for this purpose.
2.Bring the UH480 Lens into the beam. Adjust the vertical position and tilt of the Lens so that the projector beam is passing through the center of the Lens and so any residual pincushion distortion is about the same at the top and bottom of the image. This will typically result in the UH480 Lens being below the center of the projector lens and tilted slightly downward. Tighten the knobs.
3.Adjust the rotation of the ATH1 transport so that the left and right sides of the image are an equal distance from their respective screen borders. Now tighten the Pivot Screw (M380) and also the four remaining screws holding the transport to the Attachment Plate.
4.For optimum multiple aspect ratio performance, adjust the projector’s zoom so that a 1.85:1 aspect ratio movie (Lens “out”) is just masked by the top and bottom of the screen border. This way 1.85:1, 16:9 and
5.Remove the protective film from the front of the Panamorph lens
Planar
Page 16