
Recording
Motion Recording
Use Motion Recording to have the system only record when motion is detected by one of the cameras. The camera that appears

REC
A
B
Figure 7.3 Recording triggered by motion during the Motion Recording
To enable Motion Recording:
1.Press Motion on the remote control or the
2.Perform one of the following:
Enable Quad Mode (recommended): Press the Quad button. When motion is detected, the system will display the triggered camera
Enable Auto Sequence Viewing Mode: Press the
Change channels manually: Press the
ATTENTION: If you manually select a channel while the system is in Motion Recording Mode, motion recording will ONLY apply to the selected channel. For example, with Motion Recording enabled, you manually select channel 3; if motion were to occur in view of camera 1, the system would NOT RECORD video from channel 1.
3.Press Motion on the remote control or the
The “REC” indicator will only appear when motion is detected by one of the cameras
By default, the system is set to record for 15 seconds after the triggered motion event. For details on adjusting the motion recording time, see “Trigger Record” on page 35.
25