Audio Analogue SRL SIX CHANNELS POWER AMPLIFIER owner manual Troubleshooting, Cause, Remedy

11

TROUBLESHOOTING

SYMPTOM	Power leds off and no sound
CAUSE	Power cord incorrectly inserted and/or amplifier switched off
REMEDY	Check that cord is inserted both in the amplifier mains socket and in
	the wall AC outlet and that the switch is in the “on” position
CAUSE	Main fuses burnt out
REMEDY	Check the fuses in the fuse holder (unplug cord from mains first!!) next
	to the special socket and eventually replace with same type
SYMPTOM	Trigger-driven power-on not possible
CAUSE	The trigger cord is defective
REMEDY	Please replace with another cord
CAUSE	Trigger selector switched to “off” position
REMEDY	Switch the selector to “on” position
CAUSE	The preamplifier trigger output is defective or switched off
REMEDY	Check for 12V on preamplifier trigger output
SYMPTOM	Power leds red and no sound
CAUSE	Amplifier in stand by
REMEDY	Provide a signal at an adequate volume
SYMPTOM	One or more leds blinking red and no sound (speakers protection circuit
	active)
CAUSE	Short-circuits on speakers connections
REMEDY	Turn off the unit, check and connect speakers cables properly and turn
	on the unit again
CAUSE	Severe power amp overload
REMEDY	Turn off the unit, lower the listening volume of your preamplifier or check
	for damage to speakers. Then turn on the unit again.
	If the suggestions do not work, or your problem is not in the Iist,
	please contact your Audio Analogue dealer