Vivotek PZ7152, PZ7151 manual Hardware Reset

Page 6

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Hardware Reset

Ext. Int.

Mic. In

12VDC

Ethernet

Ext. I/O

Audio

Out Ext. Int.

There is an indented reset button on the side panel of the Network Camera. It is used to reboot the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the Network Camera could set the Network Camera back to normal state. If the problems remain after rebooted, restore the Network Camera to factory default and install again.

Reboot: Press and release the indented reset button with a needle. Wait for the Network Camera to reboot.

Restore: Press the indented reset button continuously for over 30 seconds until the status LED rapidly blinks red and green simultaneously. Note that all settings will be restored to factory default.

6 - User's Manual

Image 6

Contents Page Table of Contents Package contents Read before usePhysical description Rear panelDI/DO Diagram Hardware Reset Installation Hardware installationSetup the Network Camera over the Internet Network deploymentInternet connection with static IP When using a PoE-enabled switch ADSL/Cable/Hub Software installation Accessing the Network Camera Using web browsersPage Using Rtsp players Using 3GPP-compatible mobile devices MPEG-4Using Vivotek recording software Main Host Name Mjpeg protocol and media options Page Client Settings MP4 Saving Options System SystemSystem Time DI and do Add User Root PasswordSecurity Manage UserEnable Https Create and Install CertiﬁcateTo create a self-signed certificate Certificate Information Network Network TypePPPoE Point-to-point over Ethernet Page Http Https Two way audioFTP Rtsp Streaming Page Wireless LAN PZ7152 only Page Page Ddns Dynamic domain name service DdnsCustomSafe100 Access list Allowed list / Denied listDelete allowed list / Delete denied list Video settings Audio and videoGate 160945 2008/04/09 Page Page Audio settings Motion detection Percentage = 30% Preset Position Camera controlDwelling time sec Patrol selection Media Settings ApplicationSnapshot20080104100341 Server Settings Page Page Event Settings Page Recording Settings RecordingPage System log Remote LogCurrent Log View parameters Maintenance RebootRestore Calibrate Upload / Export Daylight Saving Time Conﬁguration FileUpgrade Firmware Page URL Commands of the Network Camera OverviewStyle convention Get server parameter values General CGI URL syntax and parametersSecurity level Method GET/POSTSet server parameter values Page Available parameters on the server Timezoneindex 489 ~ Group dii0~ndi-1 Group doi0~ndo-1 Group securitySubgroup of network http Subgroup of network https Subgroup of network rtspSubgroup of network pppoe Group wireless Group ipfilterPage Quality and 5 is the best quality Group audioinc0~ n-1for n channel products Adjust saturation of image according to mode settings Group upnppresentation Group upnpportforwardingPage Page Group eventi0~2 Group serveri0~4 Group mediai0~4 Group recordi0~1Drive the digital output Query status of the digital input Query status of the digital outputCapture single snapshot Account managementUpgrade ﬁrmware System logsMethod Post Camera Control Post dataRecall System InformationMethod GET Preset Locations IP ﬁlteringGet SDP of Streamings Open the network streamingsTechnical Speciﬁcations Installation, Management, and Maintenance LED IndicatorPower ApprovalsTechnology License Notice Electromagnetic Compatibility EMC