Canon FlexTT5, MiniTT1 Safety Warnings, Please pay attention to the following safety warnings

Page 2

Safety Warnings

Please pay attention to the following safety warnings:

•Operating temperature: above -15° C (5° F) and below 50° C (120° F)

•Storage temperature, without batteries: above -30° C (-22° F) and below 85° C (185° F) -- Remove batteries during storage.

•Battery Requirements: Qty. 2 AA (IEC:LR6) for FlexTT5

CR2450 or CR2354 for MiniTT1

•Do not remove instrument covers during operation.

•Do not operate the device in the presence of flammable gases or fumes. Operation of any electrical instrument in such an environment constitutes a definite safety hazard.

•There are no user serviceable parts inside the MiniTT1 or FlexTT5. Do not install substitute parts or perform any unauthorized modification of the instrument. Refer servicing only to qualified and authorized personnel.

•Red LED’s are used for dim light application and do not indicate a hazardous status.

•The MiniTT1 or FlexTT5 are accessory devices for cameras and flashes. Do not use this product in a manner not specified in documentation.

WARNING – To avoid battery leakage, follow these guidelines:

•Always remove the batteries when the unit is not in use for extended periods of time, or during shipping or long distance travel.

•Never mix old and new batteries. Always use a fresh pair of matched batteries.

•Always change batteries promptly at the first indication of low battery operation.

•Do not use or leave the unit in extreme temperature or humid environments.

2

Image 2

Contents MiniTT1/FlexTT5 for Canon Safety Warnings Please pay attention to the following safety warningsCongratulations Table of Contents Table of Contents cont’d Batteries Life expectancy = ~60 hours with alkaline batteriesMiniTT1 and FlexTT5 Key Features MiniTT1 FlexTT5 Read ME First Powering On Trigger normally Canon ST-E2 in non-ratio modeMode, not Master or Slave Basic Wireless E-TTL II MiniTT1 OOFlexTT5 cont’d Important The Speedlite in the MiniTT1’s top shoeRatio Wireless E-TTL II MiniTT1 OOFlexTT5 Ratio Wireless E-TTL II MiniTT1 OOFlexTT5 cont’d General E-TTL II ConsiderationsManual Flash Remote SpeedlitesAttempting to connect 2 flashes to the port, or Manual Flash cont’dDo not connect a flash to port. You could damage HyperSync & High Speed Sync FP Flash HyperSync & High Speed Sync FP Flash cont’d Status information Download the latest version of the Utility atUse it Advanced Features via PocketWizard Utility cont’d Channels TTLChannel Tables Learn Mode Learn Mode cont’d Special NotesFlexTT5 to the remote terminal on the camera Remote Camera TriggeringAs with other PocketWizard radios, the MiniTT1 and FlexTT5 Hand held transmitterAuto-Relay Mode Flash Idle Time Out Mode = Disabled ResetAre always reset together Turn the radio offStatus LED Good batteryVery low battery change immediately Mounting Long Range Performance Maintain at least 36 ~ 1 meter distance betweenTroubleshooting Why is my photo not properly exposed?Troubleshooting cont’d Why is my exposure bouncing around?Page Once camera sleeps, trigger will not work Canon CompatibilityFlash Units 580EX, 580EX II, 430EX, 430EX Specifications MiniTT1 FlexTT5Specifications cont’d USBPage FCC wants you to know Make IT Possible