Canon FlexTT5, MiniTT1 owner manual Batteries, Life expectancy = ~60 hours with alkaline batteries

Page 6

Batteries

CAUTION

Turn OFF your equipment (PocketWizard units, electronic flash units, cameras, etc.) before making connections or changing batteries.

FlexTT5:

Install 2 fresh AA (IEC:LR6) batteries into the FlexTT5 Transceiver. Make sure to note proper polarity. Alkaline batteries are recommended. Rechargeable or other chemistry batteries will also work, though life expectancy may vary.

Life expectancy = ~60 hours with alkaline batteries

MiniTT1:

Install a fresh CR2450 or CR2354 coin cell battery into the MiniTT1 Transmitter. Make sure to note proper polarity.

The CR2450 is recommended for longer battery life. The MiniTT1 saves batteries by automatically entering an extremely low power state when the camera enters sleep mode, or if not on a camera and TEST is not pressed for 10 seconds.

Life expectancy = 100’s of hours/thousands of triggers and varies based on usage profile

MiniTT1 and FlexTT5:

Look at the normal LED blink to determine battery level, or use the PocketWizard Utility.

LED Blink:

Green Good battery

Amber Warning – battery low

Red Very low battery – change immediately

FlexTT5 Battery Polarity

MiniTT1 Battery Polarity

CR2450 & CR2354 batteries

6

Image 6

Contents MiniTT1/FlexTT5 for Canon Safety Warnings Please pay attention to the following safety warningsCongratulations Table of Contents Table of Contents cont’d Batteries Life expectancy = ~60 hours with alkaline batteriesMiniTT1 and FlexTT5 Key Features MiniTT1 FlexTT5 Read ME First Powering On Canon ST-E2 in non-ratio mode Mode, not Master or SlaveTrigger normally Basic Wireless E-TTL II MiniTT1 OOFlexTT5 cont’d Important The Speedlite in the MiniTT1’s top shoeRatio Wireless E-TTL II MiniTT1 OOFlexTT5 Ratio Wireless E-TTL II MiniTT1 OOFlexTT5 cont’d General E-TTL II ConsiderationsManual Flash Remote SpeedlitesManual Flash cont’d Do not connect a flash to port. You could damageAttempting to connect 2 flashes to the port, or HyperSync & High Speed Sync FP Flash HyperSync & High Speed Sync FP Flash cont’d Download the latest version of the Utility at Use itStatus information Advanced Features via PocketWizard Utility cont’d Channels TTLChannel Tables Learn Mode Learn Mode cont’d Special NotesFlexTT5 to the remote terminal on the camera Remote Camera TriggeringAs with other PocketWizard radios, the MiniTT1 and FlexTT5 Hand held transmitterAuto-Relay Mode Flash Idle Time Out Mode = Disabled ResetAre always reset together Turn the radio offGood battery Very low battery change immediatelyStatus LED Mounting Long Range Performance Maintain at least 36 ~ 1 meter distance betweenTroubleshooting Why is my photo not properly exposed?Troubleshooting cont’d Why is my exposure bouncing around?Page Canon Compatibility Flash Units 580EX, 580EX II, 430EX, 430EXOnce camera sleeps, trigger will not work Specifications MiniTT1 FlexTT5Specifications cont’d USBPage FCC wants you to know Make IT Possible