Canon MR-14EXl manual Firing Only One Flash Tube

Manual Flash Mode

Firi'ngBothFlashTtllbe~$t aD,ifferentOutput

For step 3 on the preceding page, following the procedure below to set a different flash output between flash tube A and B

M

IiJ.iDI!) A : B

~tD

M

Press the <RATIO> button and select IiBml A : B •

~Each time you press the button, the selection will change in the following loop:

r--+(OFF)-~ IiBml A : B I

~IiBmlA:B:C~ I

•The flash output is displayed on the lower right of the LCD panel. When A is displayed, the flash output displayed is for flash tube A.

Press the < <J > or < C> > button to select flash tube A or B, then press the < + > or <- > button to set the flash output.

~First select the flash tube, then set the flash output for that flash tube.

•The remaining steps are the same as steps 6 and 7 on the preceding page.

Firing Only One Flash Tube

Press the <-> button and set the flash output to --. This disables the selected flash tube from firing.

•The -- setting comes after the 1/64 setting. The flash tube whose flash output is set to -- will not fire. Also, you cannot set -- for both flash tubes.

39