Canon ELAN7NE-30V, ELAN7NE-33V manual Major Specifications, Exposure control

Page 96

Major Specifications

• Exposure control

Exposure metering modes ...TTL full aperture metering with 35-zone SPC

	• Evaluative metering (linkable to any AF point)
	• Partial metering (approx. 10% of viewfinder at center)
	• Center-weighted average metering
Metering range	EV 1 - 20 (normal temperature, 50mm f/1.4, ISO 100)
Exposure control	Program AE (Full Auto, Portrait, Landscape, Close-up,
	Sports, Night Portrait, Program), shutter-priority AE,
	aperture-priority AE, depth-of-field AE, manual
	exposure, E-TTL II/A-TTL/TTL autoflash
Film speeds	ISO 6 - 6400 (Set automatically for DX-coded film within
	ISO 25 - 5000)
Exposure compensation	Manual exposure compensation: ±2 stops in 1/2-stop
	increments (can be used with AEB)
	Auto Exposure Bracketing (AEB): ±2 stops in 1/2-stop
	increments
AE lock	Auto AE lock: In One-Shot AF mode, AE lock applied
	when focus achieved.
	Manual AE lock: AE lock applied with AE lock button.
Multiple exposures	Max. 9 exposures
• Shutter
Type	Electronically controlled focal-plane shutter
Shutter speeds	1/4000 - 30 sec. in 1/2-stop increments, bulb, X sync at
	1/125 sec.
Shutter release	Soft touch electromagnetic release
Self-timer	Shoot after 10 sec. delay
Remote control	Remote Switch RS-60E3,
	Remote Controller RC-1/RC-5
• Built-in Flash
Type	Retractable, auto pop-up flash
Flash metering system	AF point-linked, 3-zone TTL autoflash
Guide No	13 (ISO 100, meters), 43 (ISO 100, ft.)
Recycling time	Approx. 2 sec.
Flash-ready indicator	Flash-ready icon lights in viewfinder
Flash coverage	28mm lens angle covered
Firing preconditions	In Basic Zones (except Landscape and Sports):
	Auto pop-up and firing in low light and backlit conditions
	in daylight.
Red-eye Reduction	Lamp
Flash exposure compensation...	±2 stops in 1/2-stop increments.

96

Image 96

Contents Instructions Page Symbols Thank you for purchasing a Canon productContents User-Controlled Shooting Handling Cautions Camera Care and StorageHow Low Battery Levels Affect Camera Operation LCD DisplaysBatteries Lens Electrical ContactsInstall the batteries Attach a lens Quick Start GuideLoad the film Batteries as shown. p.18On the lens, set the focus mode switch to AF. p.20 4Turn the Mode Dial to8Unload the film Nomenclature Mirror p.75 Contacts p.7Date Model only With an EX-series Speedlite Nomenclature LCD Panel AEBViewfinder Information Nomenclature Mode Dial CreativeBasic Zone Creative ZoneAF Mode Dial Eye Control Switch m Model onlyFilm Advance Mode Lever Conventions Used in this Instructions Reference page numbers are in parenthesesBefore You Start Attaching the StrapInstalling the Batteries Open the battery compartmentInstall the batteries Closecover. the battery compartmentChecking the Battery Level Turn the Mode Dial to a shooting modeBattery Life Mounting and Detaching a Lens Mounting a LensDetaching the Lens When it is pressed halfway When it is pressed fullyHow the Shutter Button Works 5Loading and Unloading Film Loading FilmChecking the Film Speed Move the 7 arrow to the D iconTo rewind the film in midroll, follow the procedure below Unloading Film6Midroll Rewind Press the 6 buttonDioptric Adjustment 2Turn the dioptric adjustment knobRemove the eyecup Reattach the eyecupHolding the Camera Turn the Mode Dial to Y, U, I, O, P, or a Fully Automatic ShootingYFull Auto Mode 2Aim any of the AF points on the subjectFocus the subject Press the shutter button halfway to focusAF-Assist beam with the Built-in Flash Take the pictureCompose the shot and press the shutter button fully Programmed Image Control Modes PortraitLandscape This is for wide scenic views, night scenes, etcSports Night PortraitTo cancel red-eye reduction, set W on the LCD panel Move the 7 arrow to the F icon on the LCD panel2Turn the l dial to set E on the LCD panel QUsing the Self-timer Set the film advance mode lever to pSThe K icon will be displayed on the LCD panel 2Take the pictureUsing the Eyepiece Cover Remove the eyecup from the eyepiecePush up both sides at the bottom Eyecup 2Attach the eyepiece coverImprinting the Date or Time Date Model only Press the q buttonReplacing the Date Battery AF Modes and Metering Modes Selecting the AF Mode One-Shot AF for Still Subjects AI Servo AF for Moving SubjectsAI Focus AF for Automatic AF Mode Switching Selecting the AF Mode∗ Predictive AF Basic Procedure for AF Point Selection 3Selecting an AF PointAutomatic Selection Manual Selection3Selecting an AF Point Display all AF points in redCalibration Procedure Set the Eye Control switch to eEEye Control Calibration m Model only 2Select a blinking CAL NoEEye Control Calibration m Model only 11Set the Eye Control switch to g Intelligent Eye Control Deleting Eye Control Calibration Settings Select a non-blinking CAL NoPress the w button and 3 button simultaneously GUsing Eye Control m Model only Set the Eye Control switch to e 2Select the CAL NoSet the Eye Control switch to g 4Select a shooting mode Turn the Mode Dial to select the desired shooting modeEye Control Servo AF Turning Off Eye ControlFocusing Off-Center Subjects 2Select the desired AF point Focus the subjectWhen Autofocus Fails Manual Focusing 8Manual FocusingDifficult Subjects for Autofocusing SetMF.the lens focus mode switch to 2Focus the subjectCCenter-weighted averaging metering ZMetering ModesZEvaluative metering XPartial meteringUser-Controlled Shooting Turn the Mode Dial to S Program AECheck the display 4Take the picture Difference Between S and YAbout Program Shift Turn the Mode Dial to R 2Select the desired shutter speed Shutter-Priority AEPress the shutter button halfway to focus the subject 4Check the viewfinder display and take the pictureShutter Speed Display Turn the Mode Dial to E 2Select the desired aperture value Aperture-Priority AESThe shutter speed is set automatically Depth-of-field Preview Aperture Value DisplayTurn the Mode Dial to W 2Select the desired shutter speed Manual ExposureSelect the desired aperture value 4Press the shutter button halfway to focus the subjectDetermine the exposure 6Take the pictureTurn the Mode Dial to Q. sThe AF mode will be set 2Turn the Eye Control switch to Select the AF pointDepth-of-field AE Depth-of-field AE with a Manually-Selected AF Point4Focus the nearest subject Focus farthest subject6Compose the picture and press the shutter button halfway Turn the Mode Dial to Q 2Set the Eye Control switch to g Make sure the correct CAL No. has been set. p.48Focus the nearest subject you want in focus PicturePress the shutter button halfway Depth-of-field AE 2Check the exposure setting Exposure CompensationPress the shutter button halfway and check the display Set the exposure compensation amountSThe picture will be taken in the current film advance mode LAuto Exposure Bracketing AEBMoveicon. the 7 arrow to the L Look at the LCD panel and press the 0 buttonCanceling AEB S R E Q modesJAE Lock 2Press the j button sThe j icon will lightTurn the Mode Dial to W 2Set the shutter speed to y Bulb Exposures4Start the bulb exposure. sDuring the bulb exposure, y Blinks on the LCD panel4Multiple Exposures Moveicon. the 7 arrow to2Set the desired number of multiple exposures HSelecting the Film Advance Mode Setting the ISO Film Speed2Set the desired film speed Turn the l dial to set the film speed2Set the setting to W Turn the l dial To enable the beeper to sound, set to E9Silencing the Beeper BLCD Panel IlluminationMirror Lockup Press the shutter button fully. sThe mirror will lock upSAfter 30 seconds, it will go back down automatically 2Pressagain. the shutter button fullyKWireless Remote Control Using the Remote SwitchTurn the film advance mode lever to p Flash Photography Using the Built-in Flash A Basic Zone ModeA Creative Zone Mode This mode gives the same flash result as the S modeFlash Distance Range With EF28-105mm f/3.5-4.5 ISOUsing the Built-in Flash AFlash Exposure Compensation Move the 7 arrow to the a icon on the LCD panel2Set the flash exposure compensation amount Using an EOS-dedicated Speedlite Using an EX-series SpeedliteUsing an EZ/E/EG/ML/TL-series Speedlite About E-TTL II AutoflashUsing an EOS-dedicated Speedlite Custom Functions C.Fn GSetting a Custom Function Turn the Mode Dial to G. sThe V icon and CustomSet the Custom Function setting 2Select the Custom Function NoCustom Function Settings Enabled DisabledMakes focusing and AE lock separate operations Increase the film rewind speedCustom Function Settings Disabled Normal operation Enabled1st-curtain sync 2nd-curtain sync Auto 125 sec. fixed OffButton + l u Disabled Enabled AF stop AF startAE lock while metering Basic Photography Terms ExposureShutter speed Aperture valueDepth of field Basic Photography TermsFeature Availability Table AF Mode and Film Advance Mode Combination AE Lock EffectsProgram Line Program Line DescriptionPicture looks blurred Lens focus mode switch is set to MF There was camera shake when the picture was takenR icon blinks on the LCD panel Battery level is very low Misoperation has occurredMajor Specifications Major Specifications Exposure controlFilm transport Index Shutter Button CT1-1265-000 Canon INC