28 |
| Configuring Your Camera | AXIS 2110 User’s Manual |
Reinstating the Factory Default Settings
In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS 2110. This is performed by clicking the Support link in the Administration Tools and then selecting Restart/Reset, or by pressing the Control Button. Follow the instructions below to reinstate the product factory default settings using the Control button:
1.Switch off the AXIS 2110 by disconnecting the power cable.
2.Press and keep the Control Button pressed, and then reconnect the power supply cable.
3.Keep the Control Button pressed until the Status Indicator displays yellow (note that this may take up to 15 seconds), then release the button. When the Status Indicator displays green (which can take up to 1 minute) the AXIS 2110 will then have been reset to the original factory default settings.
Notes: •Reinstating the original default settings will cause all parameters (including the IP address) to
be reset.
•Refer to Installing Your Camera on a Network, on page 10, for information on how to set the camera’s IP address.