Minolta 9222-2163-11, 2084401, 2163-910 instruction manual Care and Strage, 122 123

Page 62

9222-2163-11 MM-B108 (E).qxd 01.8.3 16:11 Page 122

CARE AND STRAGE

Operating Temperature and Conditions

This camera is designed for use from -20° to 50°C (4 to 122 °F).

Never leave your camera where it may be subjected to extreme temperatures such as in the glove compartment of a car.

The data panel response time will be slow at cold temperatures. The display will temporarily darken at high temperatures, but will be restored when the temperature normalizes.

This camera is not waterproof or splashproof. When using the camera in the rain, protect the camera and lens.

Never subject the camera to extreme humidity.

To prevent condensation from forming, place the camera in a sealed plastic bag when bringing it from cold environment to a warm environment. Allow it to come to room temperature before removing it from the bag.

The low-battery symbol may appear even with fresh batteries depending on the storage conditions. To restore camera power, repeat turning the camera on and off.

Battery capacity decreases at colder temperatures. Keep your camera and spare batteries in a warm inside pocket when shooting in cold weather. Batteries will regain some of their capacity when warmed to normal operating temperature.

Before Important Events

Check the camera’s operation carefully, or take test photographs.

Minolta is not responsible for any loss that may occur due to an equipment malfunction.

Cleaning

If the camera or lens barrel is dirty, wipe it gently with a soft, clean, dry cloth If the camera or lens comes in contact with sand, gently blow away loose particles - wiping may scratch the surface.

To clean the lens surface, first brush away any dust or sand then, if necessary, moisten a lens tissue with lens cleaning fluid and gently wipe the lens in a circular motion, starting from the center.

Never place lens fluid directly on the lens.

Never touch the interior of the camera, especially the shutter and mirror, doing so may impair their alignment and movement.

Dust on the mirror will not affect the exposure but may affect the focus. Use a blower brush to remove dust from or around the mirror.

Never use compressed air to clean the camera’s interior, it may cause damage to sensitive interior parts.

Never use organic solvents to clean the camera.

Never touch the lens surface with your fingers.

Storage

When storing your camera for extended periods,

Always attach the protective caps.

Store in a cool, dry, and well-ventilated area away from dust and chemicals such as moth balls. For long periods, place the camera in an airtight container with a silica gel drying agent.

Periodically release the camera’s shutter to keep it operating properly.

Before using after prolonged storage, check the camera’s operation to make sure it is functioning properly.

Questions and Service

If you have questions about your camera, contact your local camera

APPENDIX

 

dealer or write to the Minolta distributor in your area.

 

 

Before shipping your camera for repair, please contact an authorized

 

 

Minolta Service Facility for details.

 

122

123

Image 62
Contents Appendix Table of Contents Table of Contents Detailed OperationFor Proper and Safe USE For Proper and Safe USE Quick Operation Names of Parts BodyViewfinder Names of PartsData Panel Attaching the Strap Using the Eyepiece CapStrap Batteries Installing the BatteriesBattery Condition Indicators Lens caps LensAttaching the Lens Removing the LensFilm Film-chamber LockWait until the film is Gently press the manual- rewind button using a penRewinding the Film Completely rewoundTurning Eye-start on Handling the Camera EYE-STARTPressing the Shutter-release Button Turn the function dial toCanceling the Audio Signal Audio SignalCanceling Eye-start Turning the Audio Signal OnTaking Pictures in FULL-AUTO Special Focus Situations Focus SignalsFocus Focus cannot be confirmed BlinkingFocus Lock Using the BUILT-IN FlashFlash Signals Center your subject in the wide Focus frameFlash Range Using the BUILT-IN FlashFlash Cancel Lens ShadowingRed-Eye Reduction Canceling Red-eye ReductionWhen you release the button, Until Appear on Data panelLandscape SUBJECT-PROGRAM SelectionPortrait Sports SUBJECT-PROGRAM SelectionClose-up Night Portrait Photograping Night ScenesCenter your subject in the focus frame Self-timerDrive Modes For Owner’s of the Remote-control Model Drive ModesContinuous Adavance Recompose the picture Focus Lock in Remote Control ModeShutter-release button Lift your finger fromAperture Control Shutter ControlMode Aperture Priority Exposure ModesCanceling the Flash Mode Aperture PriorityFlash with a Mode Press the flash-mode button to pop-up the built-in flashControl dial until S appears Mode Shutter PriorityDepth-of-field Preview Select the shutter speedFlash with S Mode Mode ManualMode Shutter Priority Ev Scale in the Viewfinder Mode ManualFlash with M mode Mode Control dial to change Shutter speedsLow Light Exposure WarningsBright Light Taking Time Exposures p.81 Multiple Exposures p.90Spot Focus Area Focus AreaWide Focus Area Focus Area Local Focus AreasAppears on the data Focus ModesAutomatic AF Continuous AF Manual Focus Focus ModesSingle-Shot AF Spot Metering AF IlluminatorSegment Honeycomb-Pattern Metering Subject in the center Subject on the rightExposure AE-LOCK Spot-AE LockExposure AE-LOCK Ev Scale Display When Using the Spot-AE LockMount the camera on a tripod. Set the camera to M mode p.61 With the object to be meteredUsing the Remote-Control with BulbSold Separately Attaching the Remote Cord Sold SeparatelyExposure Compensation Checking Exposure CompensationTo set the bracketing Setting the ISO ManuallyExposure Bracketing IncrementExposure Bracketing Repeat 4 and 5 for each Additional exposure Multiple ExposureStop From blinking Down to take the lastMultiple Exposure Canceling Multiple ExposureFlash Metering Multiple ExposureFlash Metering Attaching the Accessory FlashFlash Pre-flash meteringHIGH-SPEED Sync HSS Attach the accessory flash toSlow Sync High-speed sync HSSNormal flash Wireless flash WIRELESS/REMOTE FlashSetting Wireless/Remote Flash Mode With the camera and flash on Turn the function dial toWireless/Remote Ratio Flash WIRELESS/REMOTE FlashTaking Pictures in Wireless/Remote Flash Mode 100 101Imprinting the Date or Time Canceling Wireless/Remote Flash Mode102 103 For Owners of the Quartz Date Model Setting the Date or Time104 105 Changing the Date Format106 107 Setting Custom FunctionsCustom Functions Turn the function dial to any Position other than Cust108 109 Custom FunctionsCustom 6 Focus-hold Button Lens Custom 8 P Mode Settings110 111 Custom 7 Eyepiece Sensor Activation112 113 114 115 PROGRAM-RESET ButtonFollowing settings will not change 116 117 Accessory InformationAccessory Flashes LensesAccessory Information 118 119Trouble Shooting 120Care and Strage 122 123Specifications 124 125Subject Index126 127 MM-B108