MRV Communications EM316EDFA-BR manual Module Installation, Fiber Driver EM316EDFA User Guide

Page 14

3.5 Module Installation

Fiber Driver® EM316EDFA User Guide

3.5 Module Installation

EM316xx cards are hot-swappable in a powered Fiber Driver chassis. Install the EM316xx module by aligning the edge of the card with the rail of the chassis slot. Hand-tighten the thumb screw. Do not over-tighten.

The thumb screw is on the left when installed in the BU-1, BU-2, BU-3, and BU-4 chassis. The thumb screw is on the bottom when installed in the BU-16 chassis.

3.5.1.1.1Tools

•6-inch Phillips #1 screwdriver (for some module screws)

•6-inch flat-tip 5.0 screwdriver

3.5.1.1.2Procedure

Follow all guidelines to eliminate static electricity while handling the module and other electronic devices. Refer to the front of this manual for some safety suggestions.

Step 1 Remove the blank panel or old module from the target chassis slot. Unfasten the mounting screws with a 6-inch Phillips screwdriver, or disengage any thumb screws by hand.

Figure 4 -- Remove the required blank panels

To comply with FCC regulations and for optimal cooling air flow, a cover panel or a module must cover every chassis slot. To limit external signals, no chassis slot should remain open when the unit is operational. Secure modules and panels with appropriate screws for grounding and further compliance.

P/N 1294008-001 Rev D2

5

Image 14

Contents Erbium Doped Fiber Amplifier Booster EM316EDFA-BREM316EDFA-LPR Erbium Doped Fiber Inline Pre-Amplifier2 Introduction to EM316EDFA Optical Amplifiers 3 Preparation and InstallationTable of Contents 5 Module Management6 Appendix Table of Figures1.2 Copyright 1 Preliminary Considerations1.1 Trademarks 1.3 Customer SupportFiber Driver Chassis 1.4 ComplianceFiber Driver EM316EDFA User Guide Fiber Driver Modules1.5.1Cautions and Warnings 1.5General Safety1.5.2 Laser Safety 1.5.3 Laser Device Classifications Fiber Driver EM316EDFA User Guide1.5.4 Static Electricity 1.5.5 Workplace PreparationFiber Driver EM316EDFA User Guide 1.6 About This Manual1.7 Latest Revision and Related Documents Document NumberC-band pre-amplifier 2 Introduction to EM316EDFA Optical AmplifiersFiber Driver EM316EDFA User Guide 2.1.2EDFA Control Inputs 2.1 Features2.1.3EDFA Alarm Outputs 3 Preparation and Installation 3.1 Unpacking the Fiber Driver Module3.3 LEDs 3.4 DIP Switches3.2 Front Panel Fiber Driver EM316EDFA User Guide 3.5 Module Installation3.5.1.1.2Procedure 3.5.1.1.1ToolsP/N 1294008-001Rev D2 4 EDFA Features 4.1 Network Management Control and Monitoring4.1.3 Operating Parameters 4.1.2 EM316EDFA Alarm Output Pins4.1.1 Management Control from the Network 5 Module Management RS-232 5.1 Serial Console InterfaceFiber Driver EM316EDFA User Guide Serial Port5.2 EM316LNXNM-OTCommand Line Interface CLI 5.2.1 EM316LNXNM-OTBoot and CLI Login P/N 1294008-001Rev D25.2.2 CLI Navigation 5.2.3.2“show log” 5.2.3 Login Context Commands and Examples5.2.3.1“show version” P/N 1294008-001Rev D2 5.2.3.3“show running-config”fiberdriver# show running-config P/N 1294008-001Rev D2 5.2.3.4“show startup-config”fiberdriver# show startup-config 5.2.3.5 Configuring System Parameters Fiber Driver EM316EDFA User Guide5.2.4 Chassis Context 5.2.4.1“show”P/N 1294008-001Rev D2 5.2.4.2 Other CommandsFiber Driver EM316EDFA User Guide Fiber Driver EM316EDFA User Guide 5.2.5 Slot Context Commands and ExamplesCommand DescriptionFiber Driver EM316EDFA User Guide 5.2.5.1 “?” 5.2.5.2“list” Fiber Driver EM316EDFA User Guide 5.2.5.3 “show” P/N 1294008-001Rev D2 EDFA-1 P/N 1294008-001Rev D2EM316EDFAv EM316EDFA5.2.6 Port Context Commands and Examples Fiber Driver EM316EDFA User Guide 5.2.6.1 “?”P/N 1294008-001Rev D2 5.2.6.2“list” 5.2.6.3“show” Name EDFA-port1 5.2.6.4“port description”P/N 1294008-001Rev D2 slot 1.4 type EM316EDFA rev 1 description EDFA-2 5.2.7 Displaying and Saving System ParametersP/N 1294008-001Rev D2 5.2.8 Restoring Default Parameters P/N 1294008-001Rev D26.2 Troubleshooting Basic Troubleshooting Checklist6.1 Technical Specifications 6 AppendixMRV Communications, Inc 20415 Nordhoff Street Chatsworth, CA Tel Fax