JVC WR-MG270 Recording the Video/Still Image Files, Before recording, Seal the marine case

ISeal the marine case.

z Make sure that the O-ring is not twisted, and that you did not forget to attach it.

z Make sure that foreign objects (strap, belt, dirt, etc.) have not been caught in between.

Caution

zThe risk of water leakage is extremely high if the O-ring is twisted, if you forget to attach it, or if something is trapped in the seal.

JCheck that all the operation buttons of the camera are functioning properly.

z If it is not functioning, take out the camera and insert again.

KAttach the grips.

z Attach the grips, lights or weights on the bottom of the marine case.

2 1

Large hexagonal wrench (for screwing the grips)

Recording the Video/Still Image Files

Before recording

Submerge the marine case with the camera inserted into a bathtub or water tank full of fresh water. Gradually prolong the time the marine case is submerged as follows.

z1st time: 5 ~ 10 seconds

z2nd time: 30 seconds ~ 1 minute

z3rd time: 3 minutes ~ 5 minutes (try operating the levers and buttons while the marine case is submerged).

Caution

zAlways have someone hold the marine case for you when diving into, or getting out of water, to prevent loss or damages.

zIf for any reason water leakage occurs, remove the camera battery. It may cause the camera to explode.

ATurn on the camera’s power.

z Press and hold the power button for more than 2 seconds to turn on the power. (The camera’s power lamp lights and the monitor turns on.)

ON/OFF

Note

zSometimes, due to sudden shaking or impact to the marine case, the camera’s drop detection function operates to turn off the camera’s power. When the camera’s power is turned off, turn it on again.

18