10 EN
Power
Zoom Lever
Recording
Start/Stop button
Power Switch
Dioptre
Adjustment Control
PAUSE
GETTING STARTED (cont.)
Grip Adjustment
1
2 Pass your right hand through the loop and grasp the grip.
3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Viewfinder Adjustment
1 Set the Power Switch to “ | AUTO | ” or “ | MANUAL | ” |
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the indications in the viewfinder are clearly focused.
Shoulder Strap Attachment
2
1 
1 Make sure the battery pack is removed. Following the illustration, thread the strap through the eyelet 1, then fold it back and thread it through the buckle 2.
Repeat the procedure to attach the other end of the strap to the other eyelet 3 located under the Grip Strap. Confirm the strap is not twisted.
3
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.
1 To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.