JVC GR-DVL820, GR-DVL1020 40 EN, Fade/Wipe Effects, To Deactivate The Selected Effect

40 EN FOR RECORDING (cont.)

IMPORTANT

Some Fade/Wipe Effects cannot be used with certain modes of Programme AE with special effects

(☞ pg. 38, 39). If an unusable Fade/Wipe Effect is selected, its indicator blinks or goes out.

Lock Button

MENU/BRIGHT Wheel

Power Switch

Recording Start/Stop Button

VIDEO/MEMORY Switch (GR-DVL1020/DVL820/DVL520 only; open the LCD monitor to access this switch.)

Fade/Wipe Effects

These effects let you make pro-style scene transi- tions. Use them to spice up the transition from one scene to the next.

Fade or Wipe works when tape recording is started or when you stop recording.

1 Set the VIDEO/MEMORY Switch to “VIDEO” (GR-DVL1020/DVL820/DVL520 only), then set the

Power Switch to “ MANUAL ” while pressing down the

Lock Button located on the switch.

2 Press the MENU/BRIGHT wheel in. The Menu Screen appears.

3 Rotate the MENU/BRIGHT wheel to select “ WIPE/FADER”, then press it.

4 Rotate the MENU/BRIGHT wheel to select the desired function, then press it. Selection is complete. Press the MENU/BRIGHT wheel in again.

•The WIPE/FADER Menu disappears and the effect is reserved. The indicator representing the selected effect appears.

5 Press the Recording Start/Stop Button to activate the Fade-in/out or Wipe-in/out.

To Deactivate The Selected Effect . . .

..... select “OFF” in step 4.

NOTE:

You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/Stop Button.