6 EN
How To Attach The Core Filter
Attach the Core Filter(s) (if provided with your model ☞ pg. 5) to an optional cable(s). The Core Filter reduces interference.
1
Stopper
Release the stoppers on both ends of the Core Filter.
2
3 cm
Wind once
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core Filter. Wind the cable once around the outside of the Core Filter as shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
3
Close the Core Filter until it clicks shut.
■When connecting cables, attach the end with the Core Filter to the camcorder.
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE” is set to “ON”
■Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch is set to “ AUTO ” or
“ MANUAL ” and no cassette is in the camcorder.
■Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minutes after that, the demonstration will resume.
■“DEMO MODE” remains “ON” even if the camcorder power is turned off.
■To cancel Automatic Demonstration:
1. Set the Power Switch to “ | MANUAL | ” while pressing down the |
|
|
Lock Button located on the switch and press the MENU/ BRIGHT wheel in. The Menu Screen appears.
2. Rotate the MENU/BRIGHT wheel to select “ 
SYSTEM” and press it. The SYSTEM Menu appears.
3.Rotate the MENU/BRIGHT wheel to select “DEMO MODE” and press it. The Sub Menu appears.
4.Rotate the MENU/BRIGHT wheel to select “OFF” and press it.
5. Rotate the MENU/BRIGHT wheel to select “ 
RETURN”, and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
MENU/BRIGHT Wheel
Power Switch |
Lock Button |
Sub Menu
DEMO MODE – OF F
ON