JVC GR-D290 GR-D270 manual Recording Menus, EN Menus for Detailed Adjustment

Page 32

32 EN MENUS FOR DETAILED ADJUSTMENT

Recording Menus

CAMERA

The “m CAMERA” settings are effective when the Power Switch is set to both “A” and “M”. However, the menu settings can be changed only when the Power Switch is set to “M”.

[ ] = Factory-preset

REC MODE

SNAP/SLOW

[FULL]: Snapshot mode with no frame

NEGA: Nega mode

PIN-UP: Pin-Up mode

FRAME: Snapshot mode with frame

SLOW: Live Slow mode

[FULL] NEGA PIN-UP FRAME

[SP]: To record in the SP (Standard Play) mode

LP: Long Play—more economical, providing 1.5 times the recording time.

NOTES:

●Audio Dubbing ( pg. 46) and Insert Editing

( pg. 46) are possible on tapes recorded in the SP mode.

●If the recording mode is switched, the playback picture will be blurred at the switching point.

●It is recommended that tapes recorded in the LP mode on this camcorder be played back on this camcorder.

●During playback of a tape recorded on another camcorder, blocks of noise may appear or there may be momentary pauses in the sound.

SOUND MODE

[12BIT]: Enables video recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing. (Equivalent to the 32 kHz mode of previous models)

16BIT: Enables video recording of stereo sound on two separate channels. (Equivalent to the 48 kHz mode of previous models)

ZOOM

25X: When set to “25X” while using digital zoom, the zoom magnification will reset to 25X since digital zoom will be disengaged.

[100X]*: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 25X (the optical zoom limit), to a maximum of 100X digital magnification.

800X*: Allows you to use the Digital Zoom. By digitally processing and magnifying images, zooming is possible from 25X (the optical zoom limit), to a maximum of 800X digital magnification.

For details on the procedure, refer to “Live Slow” ( pg. 37) and “Snapshot (For Video Recording)” ( pg. 38).

GAIN UP

OFF: Allows you to shoot dark scenes with no picture brightness adjustment.

[AGC]: The overall appearance may be grainy, but the image is bright.

AUTO : The shutter speed is automatically adjusted. Shooting a subject in low or poor lighting at slow shutter speed provides a brighter image than in the AGC mode, but the subject’s movements are not smooth or natural. The overall appearance may be grainy. While the shutter speed is being automatically adjusted,

“” is displayed.

MANUAL

The “q MANUAL” settings are effective only when the Power Switch is set to “M”.

[ ] = Factory-preset

DIS

OFF: Disables the function.

[ON ]: To compensate for unstable images caused by camera-shake, particularly at high magnification.

NOTES:

●Accurate stabilization may not be possible if hand shake is excessive, or depending on the shooting condition.

●The “ ” indicator blinks or goes out if the Stabilizer cannot be used.

●Switch off this mode when recording with the camcorder on a tripod.

*Available only when the VIDEO/MEMORY Switch is set to “VIDEO”.

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Digital Still Camera D.S.C. Recording Dear CustomerFor Customer Use Model No Serial NoData Battery Wipe/Fader EffectsProgram AE with Special Effects LED LightSafety Precautions Important Safety Instructions References Index EN Getting StartedConnectors IndicatorsControls Other PartsDuring D.S.C. Recording Only IntervalBright NOVVolume During Video PlaybackDuring D.S.C. Playback MICBefore Using This Camcorder How To Attach The Shoulder Strap Provided AccessoriesHow To Attach The Lens Cap How To Attach The Core Filter Close the core filter until it clicks shutStopper Core filter Cm 1-3/16 Wind oncePower Charging The Battery PackUsing The Battery Pack Maximum continuous recording timeOperation Mode Data Battery SystemUsing AC Power About BatteriesGrip Adjustment Language SettingsDate/Time Settings Power-Linked OperationViewfinder Adjustment Brightness Adjustment Of The DisplayTripod Mounting Loading/Unloading a CassetteCard To protect valuable recordingsClose the card cover To protect valuable files available only for SD Memory CardBasic Recording EN Video RecordingTape Remaining Time LCD Monitor And ViewfinderZooming Journalistic Shooting Time CodeZoom Zoom OutTo control the speaker volume Normal PlaybackQuick Review Video PlaybackBlank Search Video Playback ENShuttle Search EN Video Playback If using a VCR, go to . If not, go to stepTo AV connector Open the cover Audio/Video cable provided Installing The Battery Control GR-D290 onlyBeam Effective Area indoor use Buttons And FunctionsPlayback Zoom Playback Special EffectsFrame-By-Frame Playback Press Snapshot C. Recording ENApproximate Number of Storable Images To cancel Interval Shooting mode Normal Playback Of ImagesC. Playback Playback Zoom GR-D290 onlyAuto Playback Of Images Index Playback Of FilesRemoving On-ScreenDisplay C. Playback ENResetting The File Name Protecting Files Tape To a Memory CardTo protect the currently displayed file MenuTo Remove Protection Setting Print Information Dpof SettingDeleting Files EN Additional Features for D.S.C To Reset The Number Of PrintsInitializing a Memory Card EXECUTE, and pressMenus with Sub Menus Menus for Detailed Adjustment ENMenus without Sub Menus EN Menus for Detailed Adjustment Recording MenusRemote Wide Mode Demo ModeBeep Tele MacroCAM Reset PriorityLanguage Clock ADJPlayback Menus Blank Srch OFF / LCD / LCD/TVDATE/TIME OFF / Auto / onTo take a snapshot in the 5-second recording mode LED LightLive Slow Second RecordingSnapshot For Video Recording EN Features for RecordingNight-Alive Exposure Control Iris Lock To return to automatic exposure controlTo return to automatic iris control To lock the exposure control and the irisSpot Exposure Control White Balance AdjustmentBacklight Compensation Wipe Or Fader Effects To deactivate the selected effectSports Variable Shutter Speed 1/250 1/4000Shutter 1/250/ Shutter 1/500 Shutter 1/1000*/ Shutter 1/2000Dubbing To a VCR Editing ENTo use this camcorder as a player Following the illustrations, connectDigital Dubbing EN EditingDubbing To Or From a Video Unit To use this camcorder as a recorderUsing USB cable B Using DV cable Using USB cableUsing DV cable Insert Editing GR-D290 only To end Audio Dubbing, press Pause 9, then StopPress START/STOP to begin editing To end Insert Editing, press START/STOP, then StopTroubleshooting EN PowerAdvanced features Video and D.S.C. RecordingEN Troubleshooting Other problemsUSE Cleaning Cassette Check TAPE’S Erase Protection TABCONDENSATION, Operation Paused Please Wait TapeDUB Error Insert ErrorCard Error Check CARD’S Write Protection SwitchCleaning The Camcorder User Maintenance ENUnit in Safeguard Mode Remove and Reattach Battery Unit in Safeguard Mode Eject and Reinsert TapeBattery Packs Using Household AC Plug AdapterEN Cautions AC AdapterMemory Cards LCD MonitorMain Unit NotHow To Handle a CD-ROM Declaration of ConformityAbout moisture condensation Serious malfunctioningCamcorder ReferencesRecording Capacity Dpof SettingTerms
Top Page Image Contents