JVC YU30052-625-1 manual Docking Station Attachment, Place Camcorder in Docking Station

CONFIRM POWER-OFF STATUS Make sure the camcorder’s power is off.

PLAYBACK Basic ConnectionsEN 41

POWER DIAL

RELEASE BUTTON

TO DC INPUT JACK

AC POWER ADAPTER/CHARGER

To AC outlet

LOCK LEVER

MULTI JACK

DOCKING STATION

POWER CORD

TO DC JACK

Docking Station Attachment

When you attach your camcorder to the Docking Station, you can add many interesting effects during playback.

1

2 PLACE CAMCORDER IN DOCKING STATION

If you plan to use the MENU button while the camcorder is docked, you need to pull out its viewfinder before attaching.

3 ATTACH AND LOCKS

Press down on the camcorder and slide the Lock Lever in the direction of the arrow. The camcorder and the Docking Station are now securely attached.

•Make sure that the camcorder does not have a DC cord or an AV cable connected to it before attaching.

•When removing the camcorder, press the Release button and lift the camera out.

4 SUPPLY POWER

Connect the AC Adapter between the Docking Station and an AC outlet.

•The Docking Station cannot function using the camcorder’s battery.

5 SELECT MODE

Set the Power Dial to “PLAY”.

Using The Remote Control During Playback

Once the camcorder is attached to the Docking Station, you can use the RM-V708U remote control for regular playback, slow motion

(approx. 1/10 speed– ☞ pg. 42), Playback Zoom (☞ pg. 47), and P.AE/Effects (☞ pg. 48).

Charging The Camcorder Battery

If you attach the camcorder with the battery installed to the Docking Station, you can charge the battery. Set the Power Dial to “OFF”, then perform steps 1 through 4 of the Docking Station Attachment procedure. The Docking Station’s charging lamp starts blinking to indicate that charging has begun. When it stops blinking but stays on, charging is complete. It normally take approximately 170 minutes to charge using this method.

•Do not attach or remove the battery while the camcorder is attached to the Docking Station.