SET EDIT-IN Point, SET EDIT-OUT Point | JVC YU30052-625-1 specification

52EN EDITING (Cont.)

		PROGRAM
	1	I N	OUT MODE
	1	:	~ :
	2		~
	3		~
	4		~
	5		~
	6		~
RM-V708U (provided)	7		~
POWER DIAL	8		~
POWER DIAL	T I ME CODE		:
	TOTAL		00 : 0 0

REMOTE SENSOR	T W	RANDOM ASSEMBLE
		RANDOM ASSEMBLE
		EDITING MENU
FADE/WIPE		PLAY
EFFECT		PLAY
EFFECT
EDIT IN/OUT		R.A.EDIT ON/OFF
		CANCEL

4 SET EDIT-IN POINT

At the beginning of the scene, press EDIT IN/ OUT on the remote control. The Edit In position appears in the viewfinder and on the connected TV.

5 SET EDIT-OUT POINT

At the end of the scene, press EDIT IN/OUT. The Edit Out position appears in the viewfinder and on the connected TV.

6 USE FADE WIPE ON SCENE TRANSITION

Press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

7 USE P.AE/EFFECT

Press EFFECT.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•You can use Classic Film, Monotone, Sepia, Strobe or Video Echo effects.

8 CONTINUE EDITING Repeat steps 4 – 7.

•If you're not using Fade/Wipe or P.AE/Effects, repeat steps 4 and 5 only.

NOTES:

●When choosing a scene, set Edit-In and Edit-Out points so there’s a relatively large difference between them.

●If the search time for an in-point exceeds

5 minutes, the recording deck's Record-Standby mode will be cancelled and editing will not take place.

●If there are blank portions before or after the Edit-In and Edit-Out points, a blue-backed screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●To use a P. AE/Effect, press EFFECT on the remote control repeatedly to cycle through the effects until the one you want is displayed.

●To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

●If you use Sepia or Monotone P.AE/Effects, you can’t use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use Dissolve or Black & White Fader during Random Assemble Editing.