•If a Fade/Wipe effect was in use during Insert Editing, wait about 10 seconds after pressing STOP before performing other operations.
NOTES:
● After step 5, Retake (☞ pg. 16) can be performed. ● The tape may stop slightly before or after the
designated end point, and noise bars may appear. Neither indicates a defect in the unit.
● Only video signal is recorded in the Insert Editing mode.
Press STOP.
7
FIND EDIT-IN POINT
4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.
BEGIN INSERT EDITING
6 Press RECORDING START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.
END INSERT EDITING
RESET COUNTER
Locate the point and press PAUSE on the camcorder or the remote control.
FIND EDIT-OUT POINT
Set the Power switch to “PLAY”.
1
2
3 Press and hold COUNTER R/M for more than
2 seconds to reset the tape counter, then press for less than 1 second and make sure “M” appears in the viewfinder.
EDITING (cont.) Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
Use the RM-V706U remote control unit to perform this procedure.
SELECT MODE
42
COUNTER R/M
| POWER |
|
| |
|
|
|
| Insert editing |
w |
|
| ||
M – 0 : 1 2 : 3 4 |
| |||
|
| indicator | ||
|
|
|
| |
|
|
|
| Tape Counter |
|
|
|
| |
|
|
|
|
|
Viewfinder |
|
| ||
INSERT