JVC GR-D72 manual About moisture condensation, Serious malfunctioning, Declaration of Conformity

Page 47

CAUTIONS EN 47

About moisture condensation

You have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass’ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes and then re-connect it and proceed as usual from the beginning.

Declaration of Conformity

Model Number

: GR-D72U

Trade Name

: JVC

Responsible party

: JVC AMERICAS CORP.

Address

: 1700 Valley Road Wayne,

 

N. J. 07470

Telephone Number

: 973-317–5000

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Change or modifications not approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

REFERENCES

Image 47
Contents LYT1226-001A EN Dear CustomerFor Customer Use Safety Precautions Before recording an important scene… Important Safty InstructionsEN Contents Getting Started EN Provided AccessoriesHow To Attach The Lens Cap How To Attach The Shoulder StrapClose the core filter until it clicks shut PowerCharging The Battery Pack EN Getting StartedColder temperatures Using The Battery PackGrip Adjustment Using AC PowerInformation Operation ModeDate/Time Settings Power-Linked OperationStarted Viewfinder AdjustmentDiopter Adjustment Control Tripod MountingClose the card cover To switch the recording mode, refer to pages 25Loading/Unloading a Cassette Memory card is not providedVideo Recording & Playback Basic RecordingVideo Recording EN Tape Remaining Time EN Video RecordingVideo Journalistic Shooting Recording From The Middle Of a TapeSelf Recording Time CodeBlank Search To control the speaker volumeNormal Playback Shuttle SearchSlot Installing The BatteryVideo Playback EN Buttons And FunctionsFrame-By-Frame Playback EN Video PlaybackPlayback Zoom Slow-Motion PlaybackWhite to Audio L Red to Audio R Yellow to Video To S-VIDEO If using a VCR, go to . If not, go to stepConnections To a TV Or VCR PlaybackApproximate Number of Storable Images EN D.S.C. RecordingDigital Still Camera D.S.C. Recording & Playback Dubbing Still Images Recorded On a Tape To a Memory CardC. Recording EN EN D.S.C. Playback Normal Playback Of ImagesAuto Playback Of Images Index Playback Of FilesC. Playback EN Battery indicator disappearViewing File Information Removing On-Screen DisplayTo Remove Protection EN Additional Features for D.S.CProtecting Files Deleting FilesPrints Open the LCD monitor fully.  pg Resetting The File NameInitializing a Memory Card Folder and File namesMenus with Sub Menus Changing The Menu SettingsFeatures Menus without Sub MenusAuto EN Menus for Detailed AdjustmentRecording Menus Fine / Standard Advanced Features pg , Brightness Adjustment Of The Display  pg , Date/Time SettingsOFF / LCD / LCD/TV Playback MenusLCD / Finder Execute / ReturnTo deactivate Night-Alive Night AliveWhite LED Light Program AE With Special Effects EN Features for RecordingSelect OFF in . The effect indicator disappears Wipe Or Fader EffectsSports Motor Drive ModeAuto Focus Snapshot For Video RecordingTo return to automatic exposure control Manual FocusIris Lock Exposure ControlTo return to automatic white balance To change the settingTo lock the exposure control and the iris On the connected TV EN EditingTo use this camcorder as a recorder To use this camcorder as a playerCamcorder onto another video unit equipped with a DV Equipped With a DV Connector DigitalDubbing It is also possible to copy recorded scenes fromIt is possible to do the following things Connection To a Personal Computer Using USB cableUsing DV cable Using USB cable Using DV cableSet Narration to on or MIX.  pg Audio DubbingInsert Editing Editing ENLoading/Unloading a Cassette pg EN Additional InformationReferences Video Playback pg C. Recording pgVideo and D.S.C. Playback EN TroubleshootingPower Video and D.S.C. RecordingSubject is too bright HSet r to SPOTLIGHT.  pg Advanced features Other problemsPower Switch is set to a HSet the Power Switch to M.  pg Time Code is set to OFF HSet Time Code to ON.  pg , 27 Places subject to low temperature, images become darkHPush in the memory card a few more times.  pg Recorded in the LP mode.  pg Appears when no tape is loaded.  pgRemaining power level Appears if Audio Dubbing is attempted on a tapeCard Error Memory Cards Battery PacksUsing Household AC Plug Adapter CassettesMain Unit How To Handle a CD-ROMEN Cautions LCD MonitorDeclaration of Conformity About moisture condensationSerious malfunctioning After Use Cleaning The CamcorderEN User Maintenance Slide BATT.RELEASE 1 and remove the battery packUSB CamcorderAC Adapter EN Index Other Parts IndicatorsPOWER/CHARGE Lamp  pg ControlsREC Bright During Video Recording OnlyDuring D.S.C. Recording Only BR I GHT Blank Search Push Stop Button To CancelDuring Video Playback During D.S.C. Playback MICTerms Video/AV input S/AV Input 28, 34 Wide Mode Wide ModeTerms EN TermsGR-D72