JVC LYT0610-001A Tape END, Different, Formatted Tape, Set Date/Time, Lens CAP, DUB Error

				EN	59
	Indications		Function
		Appears if a tape is not loaded when the Recording Start/Stop Button or
	TAPE!	SNAPSHOT Button is pressed while the Power Switch is set to “ ” or
		“ ”.
	TAPE END	Appears when the tape ends during recording or playback.		(☞ pg. 13)
	DIFFERENT	Appears if a tape in another format is loaded.
	FORMATTED TAPE
		● Appears when the date/time is not set.		(☞ pg. 9)
	SET DATE/TIME!	● Appears when the built-in clock battery runs out and the
		previously set date/time is erased. Consult your nearest JVC dealer
		for replacement.
	LENS CAP	Appears for 5 seconds after power is turned on if the lens cap is attached.
	A. DUB ERROR!	Appears if Audio Dubbing is attempted on a blank portion of a tape.
				(☞ pg. 49)
	A. DUB ERROR!	● Appears if Audio Dubbing is attempted on a tape recorded in the LP
	<CANNOT DUB	mode.		(☞ pg. 49)
	ON AN LP RECORDED	● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
	TAPE>	audio.		(☞ pg. 49)
	<CANNOT DUB	● Appears if A. DUB (e) on the remote control is pressed when the erase
	ON A 16BIT	protection tab is set to “SAVE”.		(☞ pg. 49)
	RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
	COPYING FAILED	Appears if dubbing of copyguarded signals is attempted while this
		camcorder is being used as a recorder.
	E01 — E06	The error indications (E01 — E06) show what type of malfunction has
		occured. When an error indication appears, the camcorder turns off
	UNIT IN SAFEGUARD
		automatically. Remove the power supply (battery, etc.) and wait a few
	MODE REMOVE AND
		minutes for the indication to clear. When it does, you can resume using the
	REATTACH BATTERY
		camcorder. If the indication remains, consult your nearest JVC dealer.