JVC GR-DVF11, GR-DVF21 specifications 44 EN, Select Scenes

If using Playback Special Effects, press EFFECT (☞ pg. 41).

44EN

USINGTHEREMOTECONTROLUNIT(cont.)

Program

	I N	OUT MODE
1	– – – – : – – ~

2

3~

4~

5~

6~

7~

8~

TIME CODE	– – : – –	4
TOTAL	0 0 : 0 0

Random Assemble Editing Menu

SELECT SCENES (cont.)

6 At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

7 At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears in the Random Assemble Editing Menu.

Remote sensor

RM-V711U

T W

FADE/WIPE

8 If using a Fade/Wipe at the end of the scene, press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•You cannot use a Picture Wipe/Dissolve at the end of the last scene.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

9

10 Repeat steps 6 through 9 to register additional scenes. •To change previously registered points, press

CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

EFFECT

PLAY

•If you are not using Fade/Wipe or Program AE with special effects, repeat steps 6 and 7 only.

EDIT IN/OUT	R.A.EDIT
	ON/OFF

CANCEL

NOTES:

●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be canceled and editing will not take place.

●If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.