JVC LYT0217-001A, GR-DVA1 manual Viewfinder Indications, Stop Recording, Press Display Button

Tape remaining time indicator

25 min min

(Now calculating)

90min

89min

3min

2min

(Blinking)

1min

(Blinking)

0min

(Blinking)

Recording Start/Stop Button

DISPLAY

EN17

4	STOP RECORDING
	Press the Recording Start/Stop Button again to stop
	recording.
	•The camcorder re-enters the Record-Standby mode.
NOTES:
● A cassette holder cannot be opened unless a power
supply is attached.
● There may be a delay after you open the cassette cover
until the holder opens. Do not use force.
● The tape remaining time is only displayed in the
viewfinder as shown.
● The remaining time indicated in the viewfinder is
approximate.
● The time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
● “TAPE END” appears when the tape reaches its end, and
the power goes off automatically if left in this condition
for 5 minutes. “TAPE END” also appears when a cassette
whose tape is already at its end is loaded.
● If the Record-Standby mode continues for 5 minutes, the		RECORDING
camcorder’s power shuts off automatically. Set the
Power Switch to “POWER OFF”, and then back to
“CAMERA” to turn the camcorder on again.
● When a blank portion is left between recorded scenes
on the tape, the time code is interrupted and errors may
occur when editing the tape. Continue recording from
where you stop so that there are no gaps by following
“Recording from the middle of a tape” (☞ pg. 20).
● The LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on with the cover closed.
● While shooting, sound is not heard from the speaker.
Viewfinder Indications
You can make the Viewfinder indications appear/
disappear.
1	PRESS DISPLAY BUTTON
	When you do not want the indications to appear,
	press DISPLAY for longer than approximately 1
	second. Certain indications disappear.
	Press again for longer than approx. 1 second to make
	the indicaitons reappear.
NOTE:

It is impossible to make the tape running indicator “444” and warnings etc. disappear from the viewfinder. For the indications that can be removed, ☞ pgs. 64 and 65.