JVC GR-DVL865 Power is not connected, Properly, Battery is dead, Or OFF, To Memory, To Video

Page 69

TROUBLESHOOTING

EN 69

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

1

SYMPTOM

POSSIBLE CAUSES

2No power is supplied.

• The power is not connected

 

 

properly.

 

 

• The battery is dead.

3“SET DATE/TIME!” appears. • The date/time is not set.

The built-in clock battery has run out and the previously set date/time has been erased.

Recording cannot be

— For Tape Recording —

performed.

• The tape’s erase protection tab is

 

set to “SAVE”.

 

• The Power Switch is set to “PLAY”

 

or “OFF”.

 

• The VIDEO/MEMORY Switch is set

 

to “MEMORY”.

 

• “TAPE END” appears.

 

• The cassette holder cover is open.

 

— For Memory Card Recording —

 

• The VIDEO/MEMORY Switch is set

 

to “VIDEO”.

CORRECTIVE ACTION

Connect the AC Adapter securely ( pg. 9).

Replace the dead battery with a fully charged one ( pg. 8, 9).

Set the date/time ( pg. 11).

Consult your nearest JVC dealer for replacement.

Set the tape’s erase protection tab to “REC” ( pg. 12).

Set the Power Switch to “ AUTO ” or “ MANUAL ” ( pg. 17).

Set the VIDEO/MEMORY Switch to “VIDEO”.

Replace with new cassette ( pg. 12).

Close the cassette holder cover.

Set the VIDEO/MEMORY Switch to “MEMORY”.

54There is no picture.

• The camcorder is not getting power,

• Turn the camcorder’s power off and

 

or some other malfunction exists.

on again ( pg. 17).

 

 

 

The focus does not adjust

• Focus is set to the Manual mode.

• Set Focus to the Auto mode

automatically.

• The recording was done in a dark

( pg. 43).

 

place, or the contrast was low.

• Clean the lens and check the focus

 

• The lens is dirty or covered with

again ( pg. 74).

 

condensation.

 

 

 

 

 

 

CONTINUED ON NEXT PAGE

Image 69
Contents Instructions It is recommended that you Dear CustomerPage Before recording an important scene How To Attach The Lens Cap How To Attach The Core Filter Set the Power Switch toWhile pressing down Getting Started Charging the Battery Pack PowerBattery pack Charging time To Detach The Battery PackUsing the Battery Pack Using AC PowerApproximate recording time GR-DVL867/DVL865/DVL767/DVL765 Viewfinder Adjustment Grip Adjustment10 EN Shoulder Strap AttachmentMENU/BRIGHT Wheel Power Lamp Date/Time SettingsLock Button Display Display MenuApproximate recording time Tape Recording mode 12 ENLoading/Unloading a Cassette Set the tape recording mode depending on your preference Recording Mode SettingSP mode Audio Dubbing  pg and Insert EditingPicture Quality/Image Size Setting Loading a Memory CardTo Unload a Memory Card Tape Recording 16 EN To Adjust The Brightness Of The DisplayBasic Recording Remove the lens capPower Switch Position Operation ModeJournalistic Shooting SELF-RECORDING18 EN Slide the Power Zoom Lever towards TZoom Zoom OutSet Light OFF/AUTO/ON as required OFF Turns off the light To brighten the scene when natural lighting is too dim20 EN When a blank portion is recorded on a tapeTime Code Proper recordingTo Control The Speaker Volume SpeakerswitchNormal Playback Connections 22 ENCamcorder TV or VCRDate/Time Set DATE/TIME to AUTO, on or OFF Menu Screen  pg If using a VCR . . . go to step If not . . . go to step24 EN To cancel Blank Search midwayBlank Search PressMemory Card Recording Playback Basic Shooting Snapshot 26 ENTo Delete Unwanted Still Images When unwanted still images are storedTo Remove The Shutter Sound To Protect Valuable Files available only for SD Memory CardAuto Playback 28 ENType of file played back last time is played If you are viewing an Image fileIndex Playback Viewing File InformationRemoving On-Screen Display Protecting Files 30 ENTo Remove Protection Stored file is displayedDelete Screen Deleting FilesDubbing Still Images Recorded On a Tape To a Memory Card 32 ENLock Button Display Menu Screen Play/Pause Button 4/6 Stop Button MENU/BRIGHT WheelTo Make Video Clips from REAL-TIME Camera Image To cancel E-Mail Clip RecordingTo Make Video Clips from Recorded Video Footage To view video clips stored on a memory card34 EN To Reset The SettingTo Print ALL Still Images ONE Print for Each Press the MENU/BRIGHT wheel in. The Menu Screen appearsTo Reset The No. Of Prints To Print by Selecting Still Images NO. of PrintsFast-Forward 3 Button Rewind Button Making a New Folder 36 ENInitialising a Memory Card Folder and File namesAdvanced Features 38 EN To Deactivate The Selected ModeNight-Scope To Deactivate Night-ScopeMakes evening scenes look more natural Sports Variable Shutter Speed 1/250 1/4000Gives recorded scenes a strobe effect Your recording looks like a series of consecutive snapshots40 EN Power Switch Recording Start/Stop ButtonFade/Wipe Effects To Deactivate The Selected EffectMenu Effect Fader And Wipe MenuSet the VIDEO/MEMORY Switch to Video GR Snapshot Mode Selection42 EN Snapshot For Tape RecordingTo obtain correct focus While focusing on a nearer subjectFocus detection zone Subject44 EN Exposure ControlIris Lock White Balance Adjustment Manual White Balance OperationTo Return To Automatic White Balance For Recording Menu 46 ENSee pg Go to stepMenu Screen Explanations Factory-preset10X 40XFrom 01 to 99. Factory setting is Screen ratio becomes Appears. When using this mode, referNormal screen ratio Screen and the image appears like a letterboxed 169 movieGR-DVL867/DVL865/DVL767/DVL765/DVL567/DVL367/DVL365 only Refer to Picture Quality/Image Size Setting  pgTo VIDEO, still images are recorded only onto the tape Camera Menu is also applicable to memory card recordingFollowing procedure applies to all except Synchro Comp  pg 50 ENFor Playback Menu Display Playback SoundDubbing To a VCR 52 ENPress 4 to play back the source tape To use this camcorder as a playerTo DV Core filter Core filter To DV54 EN Installing The BatteriesSwitch set to the camera Set to Play With the camcorder’s Power SwitchTo allow frame-by-frame search during tape playback 56 ENTo allow you to add creative effects to the playback image Select MenuFeature Playback Zoom 58 EN SET REMOTE/VCR CodeVCR Recording deck Connect the editing cable to the R.A.EDIT Connector Connect the editing cable to the Remote Pause connectorMake Connections Also refer to pgSelect Scenes 60 ENRandom Assemble Editing Menu appears Editing MenuAutomatic Editing to VCR 62 EN Adjustment of VCR/CAMCORDER TimingFor More Accurate Editing Diagnosing VCR/CAMCORDER TimingConnector GR-DVL867 Set 12BIT Mode to Sound 2 or MIX Menu Screen  pgAudio Dubbing To hear the dubbed sound during playbackInsert Editing 64 ENUsing DV cable Using USB or PC connection cable This camcorder can be used as a WebCam via USB connection 66 ENReferences 68 EN Lithium-ion is vulnerable in colder temperaturesAbout Batteries Benefits Of Lithium-Ion BatteriesBattery is dead Power is not connectedProperly Or OFFFind a white subject and compose 70 EN10X optical zoom is selected Set Zoom to 40X or 500X Video  pgWhite Balance cannot be Sepia or Monotone mode is When shooting a subjectAre protected Stored on the memory card Delete them  pg Set the VIDEO/MEMORY 72 ENCheck the section of the manual Have become dirty ex  pg FingerprintsThat explains LCD monitor Viewfinder indicationsCleaning The Camcorder 74 ENAfter Use Use only the following batteries AAA R03 size x To prevent damage and prolong service lifeTo avoid hazards Do not burn76 EN Serious malfunctioning About moisture condensation78 EN Storage media Power requirementCompression system File size80 EN Controls, Connectors And IndicatorsPower Switch OPEN/EJECT Switch  pgAudio/Video Output Connector Ustandard Video Output Connector82 EN Index Indications1024 # @ Displays the sound mode Volume84 EN LCD Monitor/Viewfinder Indications During Tape PlaybackIndications Appears when the date/time is not set  pg86 EN Mail Clip Recording Darken The LCD MonitorFade-In/Out Gain UpUnload a Tape WebCamSee previous page as well