JVC GR-DVL867, GR-DVL865 56 EN, To allow frame-by-frame search during tape playback, Select Menu

56 EN USING THE REMOTE CONTROL UNIT (cont.)

Remote sensor

SLOW	SLOW
	Forward Button
Rewind Button	PLAY
EFFECT	PAUSE
ON/OFF
EFFECT

PLAYBACK EF FECT	PLAYBACK EFFECT
	Select Menu

OF F

1 CLASS I C F I LM

2 MONOTONE

3 SEP I A

4 STROBE

FEATURE: Slow-Motion Playback

PURPOSE:

To allow slow-speed search in either direction during tape playback.

OPERATION:

1)To change from normal to Slow-Motion Playback, press SLOW (9 or 0) more than

approx. 2 seconds. After approx. 1 minute in Slow Rewind or approx. 2 minutes in Slow Forward, normal playback resumes.

To stop Slow-Motion Playback, press PLAY (4).

NOTES:

●You can also engage Slow-Motion Playback from Still Playback by pressing SLOW more than approx. 2 seconds.

●During Slow-Motion Playback, due to digital image processing, the picture may take on a mosaic effect.

●After SLOW (9 or 0) is pressed and held, the still image may be displayed for a few seconds, followed by a blue screen for a few seconds. This is not a malfunction.

●There may be a small margin between the slow- motion playback start point you chose and the actual start point for Slow-Motion Playback.

●During Slow-Motion Playback, there will be disturbances in video and the picture may seem unstable, especially with steady images. This is not a malfunction.

●During Slow-Motion Playback, press PAUSE (6) to pause playback.

FEATURE: Frame-By-Frame Playback

PURPOSE:

To allow frame-by-frame search during tape playback.

OPERATION:

1)To change from normal to Frame-By-Frame Playback, press SLOW (0) repeatedly for forward or SLOW (9) repeatedly for reverse. Each time it is pressed, the frame is played back.

NOTE:

You can also engage Frame-By-Frame Playback from Still Playback by pressing SLOW (9 or 0) repeatedly.

FEATURE: Playback Special Effects

PURPOSE:

To allow you to add creative effects to the playback image.

OPERATION:

1)To start playback, press PLAY (4).

2)Point the remote control at the camcorder's remote sensor and press EFFECT. The PLAYBACK EFFECT Select Menu appears.

3)Move the highlight bar to the desired effect by pressing EFFECT. The selected function is activated and

after 2 seconds the menu disappears.

To deactivate the selected effect, press EFFECT ON/OFF on the remote control. Pressing it again re- activates the selected effect.

To change the selected effect, repeat from step 2 above.

NOTE:

The effects that can be used during playback are Classic Film, Monotone, Sepia and Strobe. The effects work the same in playback as they did in recording. Refer to page 39 for more information.