DISTRBUTION AMPLIFIERS
INSTALLATION | 6 |
Step 1. Connect the power cord to the unit and plug it into the power outlet. The power indicator LED on the back panel will light. This indicates that the unit is operational.
Step 2. Connect the video output of the source (computer or other
OPERATION | 7 |
The settings of the DA1322AT Distribution Amplifier can be adjusted using the Channel dip switches and Sync control switches as described in Section no. 4. There are no other adjustments necessary to operate the unit. The DA1322AT will operate successfully as long as cables are attached properly and other specifications are followed.
ACCESSORIES | 8 |
HD connector, for instance, Altinex part
#MS8102CA (6' –
Note: You may have to use an interface with your computer to provide for the appropriate signal format type and to provide for the use of a local monitor if called for.
Step 3. Next, connect the output channels of the amplifier to the display devices (i.e. monitors and /or projectors).
Step 4. Verify that the picture quality on all displays is good. If you are not receiving a signal, make sure that the display is compatible with the resolution of the computer graphics card. If the picture quality is less than perfect, check to make sure that all of your connections are solid and that you are using high quality cable.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
international calls.
Model No.
TM1271
TM1272
TM1273
TM1274
DA1293FC
DA1294FC
CB4203MR
CB4206MR
CB4212MR
CB4225MR
CB4250MR
CHB4275MR
CB42100MR
CB42150MR
CB4406MR
CB4412MR
CB4425MR
CB4450MR
CB4475MR
CB44100MR
CB44150MR
Description
TABLE MOUNT BRACKETS
1 U High, ½
1 U High, ½
1 U High, ½
1 U High, ½
RACK/TABLE MOUNT HARDWARE
HIGH RESOLUTION
3 feet,
6feet,
12 feet,
25 feet,
50 feet,
75 feet,
100 feet,
150 feet,
SUPER HIGH RESOLUTION 5- CHANNEL COAX CABLE
6feet,
12 feet,
25 feet,
50 feet,
75 feet,
100 feet,
150 feet,
6