DISTRBUTION AMPLIFIERS
|
|
|
| VGA TO RGB ADAPTER CABLES |
| ||
| MS8102CA |
| BNC Male, 6ft |
| |||
|
|
|
|
|
| ||
| MS8104CA |
| BNC Male, 15ft |
| |||
|
|
|
|
|
| ||
| MS8105CA |
| BNC Male, 50 ft |
| |||
|
|
|
|
|
| ||
| MS8112CA |
| BNC Male, 6ft |
| |||
|
|
|
|
|
| ||
| MS8114CA |
| BNC Male, 15ft |
| |||
|
|
|
| POWER CABLES |
|
|
| PS5301US |
|
| Power Cable for US |
|
|
| PS5302UK |
| Power Cable for UK |
|
| |
|
|
|
|
|
| |
| PS5303AU |
| Power Cable for Australia |
|
| |
| PS5304GR |
|
| Germany |
|
|
|
|
|
| |||
| FREQUENTLY ASKED QUESTIONS | 9 |
| |||
6
cat 5 cable instead of coaxial cable?
What is the maximum resolution I can pass through the DA1322AT?
instead coaxial cable, because you will loose the quality of the receiving signal. Due to this, we do not have isolation of each wire; the signals will interfere with each other.
Resolution format describes the number of pixels and lines in a given video image, as well as the rate at which each frame is
No: 
Question
1How many feet of cable may I use with the DA1322AT?
2Are the outputs of the
DA1322AT
buffered?
3What is meant by buffered output?
4If the input of the
DA1322AT provides an
RGBHV format signal what is available on the output?
5
May I use
Answer
The DA1322AT offers individual channel adjustment for gain and peaking, allowing specific control over the outputs for different lengths of cable.
Yes, the DA1322AT offers two individually buffered outputs.
Buffered output means that the output signal is isolated from the input signal. The loaded output does not affect the input, or any other output on the device. A buffered output may vary in terms of the gain or peaking adjustments made to the video signal
The DA1322AT offers sync combining and separating functions. If the input provides RGBHV, on the output you may have RGBS, You may also have RGBS on the input and RGBHV on the output.
You can not use cat 5 cable
bandwidth close 500 MHz, the DA1322AT allows even very high resolution video signals to pass without degrading the image quality.
TROUBLESHOOTING GUIDE | 10 |
We have carefully tested and have found no problems in supplied the DA1322AT unit; however, we would like to offer the following suggestions:
∙Please make sure that input amplitude of the analog signal is less than 1.5V.
∙Please make sure that the proper quality of cables is used. We recommend Altinex made cables for best results.
∙If a problem shows up after continuous usage at higher voltage, higher temperature, higher humidity, or at other extreme environmental conditions, please correct the problem. NOTE: The sync pulse voltage must be at least 1.4 volts for proper operation of the distribution amplifier. If lower voltage is used, contact Altinex for additional information.
7